Exmark Laser Z XS Operator's Manual page 33

For Exmark Mower Parts Call 606-678-9623 or 606-561-4983
4.1.16
4.1.17
∗ See Section 4.1.14 c) for special lubrication instructions on the front caster pivots and
Section 4.1.15 for special lubrication instructions on the front casters wheel hubs.
No. 6 (Mule Drive Belt Idler Arm)
Located Under Engine Frame
No. 7 (Pump Drive Belt Idler Arm)
Located Under Engine Frame
Check condition of belts:
Service Interval: 40 hrs.
a) Stop engine, wait for all moving parts to stop, and remove key.
b) Unhook seat latch and tilt seat up. Remove the air detector panel on front
side of the engine compartment to check pump drive belt.
c) Remove left and right belt shields on deck and lift up floor pan to inspect
deck drive belt.
d) Check under machine to inspect the mule drive belt.
e) See Sections 4.2.3, through 4.2.5 for belt adjustment.
Lubricate grease fittings:
Service Interval: Refer to chart.
a) Stop engine, wait for all moving parts to stop, and remove key.
b) Lubricate fittings with one to two pumps of NGLI grade #2 multi-purpose
gun grease.
Refer to the following chart for fitting locations and lubrication schedule.
LUBRICATION CHART
FITTING
LOCATIONS
1. Front Caster wheel hubs
2. Front Caster Pivots
3. Height Adj. Shaft Bearings
4. Deck Drive Belt Idler Arm
5. Brake Brackets
6. Mule Drive Belt Idler Arm
7. Pump Drive Belt Idler Arm
8. Deck Rear Struts
c) Lubricate front caster pivots once a year. Remove hex plug and cap. Thread
grease zerk in hole and pump with grease until it oozes out around top bearing.
Remove grease zerk and thread plug back in. Place cap back on.
www.mymowerparts.com
INITIAL NO. of
PUMPS PLACES
∗0
2
∗0
2
1 5
1 1
1 2
1 1
1 1
1 2
- 28 -
SERVICE
INTERVAL
∗yearly
∗yearly
40 hours
Yearly
200 hours
Yearly
Yearly
40 hours