Names And Function Of Wired Remote Controller; Avec Fil; Verkabelten Fernbedienung; Nomi E Funzioni Del Telecomando Cablato - Toshiba RAV-SM562KRT-E Owner's Manual

NAMES AND FUNCTION OF WIRED REMOTE CONTROLLER

Display section
In the display example, all indicators are displayed for the explanation.
In reality only, the selected contents are indicated.
• When turning on the leak breaker at the first time, [SET DATA]
flashes on the display part of the remote controller. While this
display is flashing, the model is being automatically confirmed.
Accordingly, wait for a while after [SET DATA] display has
disappeared, and then use the remote controller.
1
4
6
1 SET DATA display 1 1 1 1
Displayed during setup of the timer.
2 Operation mode select display 2 2
2 2
The selected operation mode is displayed.
3 3
3 CHECK display 3 3
Displayed while the protective device works or a
trouble occurs.
4 4 4 Timer time display 4 4
Time of the timer is displayed.
(When a trouble occurs, the check code is
displayed.)
5 5 Timer SETTING setup display 5
5 5
When pushing the Timer SETTING button, the
display of the timer is selected in order of
→
[OFF]
→ No display.
[ON]
6 6
6 Filter display 6 6
If "FILTER " is displayed, clean the air filter.
7 7 TEST run display 7 7 7
Displayed during a test run.
8 Flap position display 8 8
8 8
Displays flap position.
9 SWING display 9 9 9 9
Displayed during up/down movement of the flap.
! ! ! Set up temperature display ! !
The selected set up temp. is displayed.
" "
" Remote controller sensor display " "
Displayed while the sensor of the remote
controller is used.
EN
2
3
SET DATA SETTING
5
H
&
[OFF] repeat OFF timer →
7 8 9
CODE No.
TEST
UNIT No.
R.C. No.
# PRE-HEAT display # # # #
Displayed when the heating operation starts or defrost
operation is carried out.
While this indication is displayed, the indoor fan stops
or the mode enters in LOW.
$ $ $ Operation ready display $ $
Displayed when cooling or heating operation is
impossible because the outdoor temperature goes out
of the operable range.
% %
% % No function display %
Displayed if there is no function even if the button is
pushed.
& & & Air volume select display & &
The selected air volume mode is displayed.
(AUTO)
(MED.)
( ( ( Mode select control display ( (
Displayed when pushing "Operation mode select
button while the operation mode is fixed to heating or
cooling by the system manager of the air conditioner.
) Central control display ) )
) )
Displayed when using the remote controller together
with the central control remote controller, etc.
If remote controller is prohibited at the central control
side,
/
(The contents available to be set up on the remote
controller differ according to the central control mode.
For details, refer to Owner's Manual of the central
control remote controller.)
15
SET DATA SETTING TEST
UNIT No.
R.C. No.
H
TEMP.
TIMER SET FAN
TIME SWING/FIX
FILTER
RESET TEST SET CL UNIT
!
"
#
(HIGH)
(LOW)
flashes when operating
buttons and the change is not accepted.
CODE No.
Display
section
ON / OFF
Operation
MODE
VENT section
)
(
$
%
"
ON / OFF
MODE
, ,