Operating The Homelink Universal Transceiver; Erasing Programmed Buttons; Reprogramming A Single Homelink Button - Volvo S40 2005 Owner's Manual

2005 Volvo S40
To train a rolling code garage door opener, follow these instructions after programming the desired
transceiver button according to "Programming the transceiver." The help of a second person may make
training easier.
1. Locate the training button on the garage door opener motor head unit. The location and color of the
training button may vary. If you encounter difficulty, refer to the garage door opener owner's manual or
call toll-free 1-800-355-3515
(Internet: www.HomeLink.com).
2. Press the "training" button on the garage door opener motor head unit until the "training" light comes
on.
3. Press and release the programmed HomeLink button. Press and release the programmed HomeLink
button a second time to complete the training process.
4. Some garage door openers may require you to do this procedure a third time to complete the training.
5. The programmed button on your HomeLink Universal Transceiver should now operate your garage
door opener. The original handheld transmitter can also be used, as desired, to operate the garage door.
The remaining two HomeLink buttons can be programmed in the same way. In the event of any
problems in programming the HomeLink Universal Transceiver, call toll-free 1-800- 355-3515 (Internet:
www.HomeLink.com).

Operating the HomeLink Universal Transceiver

Once programmed, the HomeLink Universal Transceiver can be used in place of your handheld
transmitters.
To operate, the key must be turned to the "accessory" position (II) or the engine must be running. Press
the programmed HomeLink button to activate the garage door, driveway gate, security lightning, home
security system etc.
Your original hand-held transmitters may, of course, be used at any time.

Erasing programmed buttons

Individual buttons cannot be erased, To erase all three programmed buttons:
1. Turn the ignition key to the "accessory" position (II).
2. Hold down the two outside buttons on the HomeLink Universal Transceiver for about 20
pg. 65 Home Link® Universal Transceiver (option)
seconds, until HomeLink's indicator light begins to flash.
3. Release both buttons.
The HomeLink buttons can be reprogrammed using the procedures described on the previous page.

Reprogramming a single HomeLink button

1. Press and hold the desired HomeLink button. Do not release the button until step 3 has been
completed.
2. When the indicator light begins to flash slowly (after approximately 20 seconds), position your hand-
http://new.volvocars.com/ownersdocs/2005/2005_S40/05s40_03b.htm (17 of 18)8/12/07 12:15 AM