Reset To Factory Settings; Universal Transceiver; Programming The Transceiver - Volvo S40 2005 Owner's Manual

2005 Volvo S40
depending on the ambient temperature. Select On/Off depending on whether the recirculation timer is to
be active or not.

Reset to factory settings

Use this alternative to return to the default climate system settings.
pg. 63 Home Link® Universal Transceiver (option)
Introduction
HomeLink* is an advanced system that can be programmed to learn the codes of three different remote
controlled-devices (e.g., garage door openers, remote lighting, entry door lock). HomeLink's sun visor-
mounted transceiver, powered by your car's electrical system, may then be used in place of your hand-
held remote controls.
NOTE: For your security, the HomeLink Universal Transceiver is designed to not function if you lock
your car from the outside.
* HomeLink is a registered trademark of Johnson Controls, Intl.
© JCI, All rights reserved

Programming the transceiver

1. The ignition switch must be turned to the "accessory" position (II) before programming the HomeLink

Universal Transceiver.

2. Begin by erasing all 3 factory default channels. Hold down the two outside buttons (the left and right
buttons in the illustration) on the HomeLink Universal Transceiver for about 20 seconds, until
HomeLink's indicator light begins to flash. Then release the buttons.
3. Hold your hand-held transmitter (garage door opener, for example) 2 to 5 in. (5 to 12 cm) away from
the HomeLink surface, keeping the indicator light in view. For placement questions, contact HomeLink
http://new.volvocars.com/ownersdocs/2005/2005_S40/05s40_03b.htm (15 of 18)8/12/07 12:15 AM