Removing The Power Over Ethernet Module - Fujitsu FUTRO S900 Operating Manual

System expansions

Removing the Power over Ethernet module

Power overEthernetmodule,
► Open the casing (see
► If a PCI or PCIe board is installed, remove the cross piece and PCI or PCIe
board (see "Removing the board", Page 38 -
► Undo the screws (1).
► Pull the Power over Ethernet module in the direction of the arrow (2) out
of the slot and lift it out of the casing.
► Reinstall the cross piece and the PCI or PCIe board if necessary (see
"Installing the board", Page 36 -
► Close the casing (see
Ensure that cables are not trapped between the casing and the components.
Fujitsu Technology Solutions
"Opening the casing", Page 20 -
1
English).
"Closing the casing", Page 21 -
English).
English).
1
2
English).
English - 35
77