Advertisement
Button Functions
(1) Feed labels
When the printer is ready, press the button to feed one label to the beginning of next label.
(2) Pause the printing job
When the printer is printing, press the button to pause a print job. When the printer is paused the LED will blink green.
Press the button again to continue the printing job.
Diagnostic Tool
The Diagnostic Utility is a toolbox that allows users to explore the printer's settings and status; change printer settings;
download graphics, fonts, and firmware; create printer bitmap fonts; and to send additional commands to the printer.
Using this convenient tool, you can explore the printer status and settings and troubleshoot the printer.
Note: This utility works with printer firmware V6.00 and later versions.
Start the Diagnostic Tool:
(1) Double click on the Diagnostic tool icon
(2) There are four features (Printer Configuration, File Manager, Bitmap Font Manager, Command Tool) included in the
Diagnostic utility.
Features tab
Printer functions
Printer Status
(3) The detail functions in the Printer Function Group are listed as below.
* For more information and features about this printer, please refer to the User's Manual inside the CD disk.
Function
Initialize the printer and restore the settings to
Factory Default
factory default.
Dump Text
To activate the printer dump mode.
Configuration Page
Print printer configuration.
RTC Setup
Synchronize printer Real Time Clock with PC.
Calibrate the sensor specified in the Printer
Calibrate Sensor
Setup group media sensor field.
Reset Printer
Reboot the printer.
Print Test Page
Print a test page.
Ignore AUTO.BAS
Ignore the downloaded AUTO.BAS program.
Setup the IP address, subnet mask, gateway for
Ethernet Setup
the on board Ethernet.
to start the software.
Description
Interface
Printer setup
Advertisement
