Advertisement
Loading the Media
(1) Open the printer top cover by
pulling the tabs located on each
side towards the front of the printer,
then lift the top cover to the
maximum open angle.
(4) Place the paper, printing side face
up, through the media sensor and
place the label leading edge onto
the platen roller.
* Loading Path for Media
(7) Use "Diagnostic Tool" to set the media sensor type and calibrate the selected sensor. (Start the "Diagnostic tool"
Select the "Printer Configuration" tab Click the "Calibrate Sensor" button ) Please refer to the diagnostic utility quick
start guide for more information.
Note:
Please calibrate the gap/black mark sensor when changing the media.
(2) Separate and hold open the media
holders.
(5) Move the media guides to fit the label
width by turning the guide adjuster
knob.
.
(3) Place the roll between the holders
and close them onto the core.
Press down the media holder lock
switch to hold the label roll firmly.
(6) Disengage the top cover support
and close the top cover gently.
Advertisement
