Connecting Scansnap By Switching To Direct Connect Mode; When The Registered Wireless Access Point Is Not Detected - Fujitsu iX100 Connection Manual

Connecting ScanSnap by switching to
Direct Connect Mode
This is the connection method for when switching to Direct Connect mode after connecting ScanSnap in
Access Point Connect mode either at home or in an office.
When the registered wireless access point is not
detected
ScanSnap switches to Direct Connect mode automatically if a wireless access point which has been
previously configured in ScanSnap cannot be detected.
 To connect to a computer directly
Please see below for details.
How to connect ScanSnap to a computer directly
How to connect ScanSnap to a computer directly
 To connect to a mobile device directly
Please see below for details.
How to connect ScanSnap to a mobile device directly
How to connect ScanSnap to a mobile device directly
10