Fujitsu iX100 Connection Manual page 4

Priority sequence of Wireless mode
The priority sequence of the wireless mode at the time when a computer or mobile device is connected
to ScanSnap is as follows:
1 Access Point Connect mode
2 Direct Connect mode
If a wireless access point has already been registered to ScanSnap, the ScanSnap searches the
registered wireless access point first when connecting in Access Point Connect mode. When the
wireless access point cannot be detected, the ScanSnap switches to Direct Connect mode. Once the
wireless mode is switched to Direct Connect mode, the ScanSnap does not switch back to Access Point
Connect mode even if the registered wireless access point is found. In order to connect in Access Point
Connect mode, turn OFF the ScanSnap, and turn it ON again.
Hint
You can select the wireless mode to either Access Point Connect mode or Direct Connect mode with
ScanSnap Wireless Setup Tool. Refer to below for more details.
How to change the setting after connecting ScanSnap
How to change the setting after connecting ScanSnap
4