Mb Intelligent Bios Iii) Menu - ECS A78F2P-M2 User Manual

M.I.B. III (MB Intelligent BIOS III) Menu
This page enables you to set the clock speed and system bus for your system. The
clock speed and system bus are determined by the kind of processor you have
installed in your system.
Main Advanced
Core Clock multiplier
Memory Clock
Memory Clock is:
(XMP Profile1 DDR3-2400 10-11-11-30)
Memory Profiles2:
Memory Profiles3:
Memory Timing Configuration
Load Memory Profile
Command Rate
CAS# Latency(tCL)
RAS# to CAS# Delay (tRCD)
Row Precharge Time (tRP)
RAS# Active Time (tRAS)
Read CAS# Precharge (tRTP)
Row Cycle Time (tRC)
Write Recovery Time (tWR)
Active to Active Delay (tRRD)
Write to Read Delay (tWTR)
Four Active Window Delay (tFAW)
Row Refresh Cycle Time 0 (tRFC0)
Row Refresh Cycle Time 1 (tRFC1)
Row Refresh Cycle Time 2 (tRFC2)
Row Refresh Cycle Time 3 (tRFC3)
SB Spread Spectrum
Core Clock multiplier (Auto)
This item is used to set Core clock multiplier.
Memory Clock (Auto)
This item is used to set Memory clock.
Memory Clock is: (DDR3-1600/800Mhz)
This item shows current memory clock.
XMP Profile 1 DDR3-2400 10-11-11-30 (Ready)
This item shows the state of XMP profile 1 DDR3-2400 10-11-11-30.
Memory Profiles2~3 (None)
These items show the information of performance memory profile2~3.
Memory Timing Configuration (Auto)
This item shows the information of Memory Timing.
Load Memory Profile (Disabled)
This item enables or disables you to load memory profile.
Command Rate (2T)
This item shows the information of Command Rate.
CAS# Latency (tCL) (9)
This item determines the operation of DDR SDRAM memory CAS(column address
strobe). It is recommanded that you leave this item at the default value. The 2T
setting requires faster memory that specifically supports this mode.
A78F2P-M2 USER MANUAL
Chipset M.I.B III
Auto
Auto
(DDR3-1600/800Mhz)
Ready
None
None
Auto
Disabled
2T
9
9
9
26
6
37
12
5
6
24
4
3
4
4
Enabled
Boot Security
Core Clock multiplier
 : Select Screen

/Click: Select Item
Enter/Dbl Click : Select
+/- : Change Opt.
F1: General Help
F2: Previous Values
F3: Optimized Defaults
F4: Save & Exit
ESC/Right Click: Exit
Exit
43