Fasten Junction Box; Readjusting Foot Levels - Blomberg DWT 14210NBL00 Installation Manual

Figure D
1 /
(3,5mm)
Ø 8 "
1 /
(3,5mm)
Ø 8 "

7.1.6. FASTEN JUNCTION BOX

1. Pull the wires into the junction box. Be sure that the
wire nuts do not loosen.
2. Replace the cover on the junction box.
3. Secure the cover with the screws (Figure D).

7.2 READJUSTING FOOT LEVELS

Now that the dishwasher is in the cabinet you must
readjust the feet to bring the dishwasher up to the
required height and attach it underneath the countertop.
1. Readjust the front foot levels with adjusting wrench
to balance the dishwasher and raise it up under the
countertop, make sure the unit is level.
2. Readjust the rear foot levels with a screwdriver to
balance the dishwasher and raise it to the required
height using the brackets supplied.
3. Attach the dishwasher underneath the countertop
with the four screws supplied (Ø
x 14 mm). Make sure you do not go through the top
of the countertop or damage granite.
15
1 / " x 5 / " - Ø 3.5 mm
8 8