Displaying System Information; Restoring Factory Default Settings In Setup Utility; Exiting Setup Utility; Using Hp Pc Hardware Diagnostics (Uefi) - HP EliteBook 745 G2 Maintenance And Service Manual

● To close a text box or return to the menu display, press esc.
●
To display additional navigation and selection information while Setup Utility is open, press f1.

Displaying system information

1. Start Setup Utility.
2. Select the Main menu. System information such as the system time and date, and identification
information about the computer is displayed.
3. To exit Setup Utility without changing any settings, use the arrow keys to select Exit > Exit Discarding
Changes, and then press enter.

Restoring factory default settings in Setup Utility

1. Start Setup Utility.
2. Use the arrow keys to select Exit > Load Setup Defaults, and then press enter.
3. When the Setup Confirmation is displayed, press enter.
4. To save your change and exit Setup Utility, use the arrow keys to select Exit > Exit Saving Changes, and
then press enter.
The Setup Utility factory settings take effect when the computer restarts.
NOTE: Your password, security, and language settings are not changed when you restore the factory
settings.

Exiting Setup Utility

● To exit Setup Utility and save your changes from the current session:
If the Setup Utility menus are not visible, press
keys to select Exit > Exit Saving Changes, and then press enter.
● To exit Setup Utility without saving your changes from the current session:
If the Setup Utility menus are not visible, press
keys to select Exit > Exit Discarding Changes, and then press enter.

Using HP PC Hardware Diagnostics (UEFI)

HP PC Hardware Diagnostics is a Unified Extensible Firmware Interface (UEFI) that allows you to run
diagnostic tests to determine whether the computer hardware is functioning properly. The tool runs outside
of the operating system so that it can isolate hardware failures from issues that are caused by the operating
system or other software components.
To start HP PC Hardware Diagnostics UEFI:
1. Turn on or restart the computer, quickly press esc, and then press f2.
The BIOS searches two places for the diagnostic tool in the following order:
a. Connected USB drive
116 Chapter 9 Using Setup Utility (BIOS) and System Diagnostics in Ubuntu
esc to return to the menu display. Then use the arrow
esc to return to the menu display. Then use the arrow
ENWW