Table of Contents
Advertisement
BASE AND COLUMN ASSEMBLY (FIG.6)
1. Position the base on the floor. Remove the protective covering and
discard.
2. Remove protective sleeve from the column and discard. Place the
column assembly on the base, align the holes in the column support
with the holes in the base.
3. Locate three long bolts from the parts bag.
4. Install a bolt in each hole through the column support and the base
and tighten with the ajustable wrench.
INSTALLATION OF THE TABLE/SUPPORT ASSEMBLY AND
HARDWARE (FIG.7)
1. Locate the table/support assembly.
2. Slide the table/support assembly onto the column.
3. Locate the support lock handle among the loose parts.
4. Install the support lock handle from the left side into the table
support. Raise the table to working height by sliding it on the
column and then by tightening the lock handle by hand.
INSTALLING THE HEAD (FIG.8)
1. Remove the protective covering from the head assembly.
2. Carefully lift the head above the column and slide it down on the
column as far as it will go. Align the head with the table and the
base.
3. Using a 4mm hex. wrench, tighten the head set screws on the right
side of the head.
INSTALLING THE CHUCK (FIG.9)
1. Locate the chuck in the box of parts.
2. Clean out the tapered hole in the chuck, also clean the spindle nose
with a clean cloth. Make sure there are no foreign particles sticking
to the surfaces. The slightest piece of dirt on the spindle nose or the
chuck will prevent the chuck from seating properly. This will cause
the drill to "wobble".
NOTE: If the tapered hole in the chuck is extremely dirty, use a
cleaning solvent on a clean cloth.
3. Push the chuck up on the spindle nose as far as it will go.
4. Turn the chuck sleeve clockwise and open the chuck jaws
completely.
5. Lightly tap the nose of the chuck with a piece of wood to insure the
proper seating of the chuck on the spindle.
ASSEMBLY INSTRUCTIONS
Base
FIGURE 6
Table support
Support
lock handle
FIGURE 7
Head locking
set screws
FIGURE 8
Chuck sleeve
FIGURE 9
Table/Support
assembly
Column
Table
Column
Head
Spindle nose
Advertisement
Table of Contents
