Electrical Connections - King Canada KC-108C Instruction Manual

Hide thumbs Also See for KC-108C:

Service manual (4 pages)

Table Of Contents

Table of Contents

ALL ELECTRICAL CONNECTIONS MUST BE DONE BY A QUALIFIED ELECTRICIAN. FAILURE TO COMPLY MAY RESULT IN

SERIOUS INJURY!ALL ADJUSTMENTS OR REPAIRS MUST BE DONE WITH THE DRILL PRESS DISCONNECTED FROM THE POWER

SOURCE. FAILURE TO COMPLY MAY RESULT IN SERIOUS INJURY!

POWER SUPPLY

WARNING: YOUR DRILL PRESS MUST BE CONNECTED TO

A 110V, 15-AMP, BRANCH CIRCUIT AND USE A 15-AMP TIME

DELAY FUSE OR CIRCUIT BREAKER. FAILURE TO CONNECT IN

THIS WAY CAN RESULT IN INJURY FROM SHOCK OR FIRE.

Your drill press must be properly grounded. Not all outlets are

properly grounded. If you are not sure if your outlet is properly

grounded, have it checked by a qualified electrician.

WARNING: IF NOT PROPERLY GROUNDED, THIS DRILL

PRESS CAN CAUSE ELECTRICAL SHOCK, PARTICULARLY

WHEN USED IN DAMP LOCATIONS. TO AVOID SHOCK OR FIRE,

IF THE POWER CORD IS WORN OR DAMAGED IN ANY WAY,

HAVE IT REPLACED IMMEDIATELY.

GROUNDING

This drill press must be grounded. If it should malfunction or

breakdown, grounding provides a path of least resistance for electric

current, to reduce the risk of electric shock. This drill press is

equipped with a cord having an equipment-grounding conductor

and grounding plug. The plug must be plugged into an appropriate

outlet that is properly installed and grounded in accordance with all

local codes and ordinances.

WARNING: TO MAINTAIN PROPER GROUNDING OF YOUR

DRILL PRESS, DO NOT REMOVE OR ALTER THE GROUNDING

PRONG IN ANY MANNER.

110V OPERATION

As received from the factory, your drill press is ready to run for 110V

operation. This drill press is intended for use on a circuit that has an

outlet and a plug which looks like the one illustrated in Fig.3.

WARNING: DO NOT USE A TWO-PRONG ADAPTOR FOR

THEY ARE NOT IN ACCORDANCE WITH LOCAL CODES AND

ORDINANCES. NEVER USE IN CANADA.

EXTENSION CORDS

The use of any extension cord will cause some loss of power. Use the

following table to determine the minimum wire size (A.W.G-American

Wire Gauge) extension cord. Use only 3-wire extension cords which

have 3-prong grounding type plugs and 3-hole receptacles which

accept the tool's plug.

For circuits that are further away from the electrical circuit box, the wire

size must be increased proportionately in order to deliver ample

voltage to the dust collector motor. Refer to Fig. 4 for wire length and

size.