Advertisement
MAIN OUTPUT 6.35mm (¼") SOCKETS
Connect directly from the mixer directly to the amplifier. The
MAIN OUTPUT connectors are unbalanced mono 6.35mm
(¼") jackplugs. The main mix fader adjusts the volume to this
output.
CONTROL ROOM OUTPUTS 6.35mm (¼") SOCKETS
The control room outputs normally connected to a monitor
system in the control room and provides the stereo mix or,
when required, the solo signal.
OUTPUT TAPE 6.35mm (¼") SOCKET - This takes the out-
put signal from the main mixer and sends it to any recordable
device, e.g. tape, cd or laptops.
Note: With an adapter it may be possible to put your laptop
into the input and into the output at the same time. So you
can send a signal into the mixer and record the signal com-
ing out from the main mix fader.
INPUT TAPE 6.35mm (¼") SOCKET - This takes any ana-
logue line level signal and sends it to the main mix fader. This
could be anything from tape to MP3 players.
LED DISPLAY
The top two LEDS are power on the left and phantom power
(+48V) on the right. The green, yellow and red led's are indi-
cators for the signal level. If all the LEDS illuminate then the
signals are too high. Use the MAIN MIX fader to lower the
signal levels. Signals may be distorted if the signal levels are
set to high.
PHANTOM POWER SWITCH - Press this button when you
need +48V (see mic1).
FX DIAL - Controls the gain of all the FX busses and sends
the signal to the FX OUTPUT.
7
Advertisement
