Front Panel - D-Link DES-1210-28 User Manual

1 Product Introduction
D-Link Web Smart Switch User Manual
L2 network segment. With this utility, users do not need to change the IP address of PC and provides easy
initial setting of smart switches. The switches within the same L2 network segment connected to user's local
PC are displayed on the screen for instant access. It allows extensive switch configuration setting, and basic
configuration of discovered devices such as a password change or firmware upgrade.
Users can also access the Switch via Telnet. Basic tasks such as changing the Switch IP address, resetting
the settings to factory defaults, setting the administrator password, rebooting the Switch, or upgrading the
Switch firmware can be performed using the Command Line Interface (CLI).
In addition, users can utilize the SNMP MIB (Management Information Base) to poll switches for information
about the status, or send out traps of abnormal events. SNMP support allows users to integrate the switches
with other third-party devices for management in an SNMP-enabled environment. D-Link Web Smart
Switches also come with the D-View plug-in module that works with D-View 6, SNMP Management Software
which provides easy-to-use graphic interface and facilitates the operation efficiency.
DES-1210-08P
8-Port 10/100Mpbs PoE Web Smart Switch

Front Panel

Figure 1 – DES-1210-08P Front Panel
Power LED : The Power LED lights up when the Switch is connected to a power source.
Power Max LED: The Power Max lights up when the system power resource remain ≦7W, in the meantime,
system will not provide power to the additional PoE PD inserted.
Fan OK/Fail LED: The FAN LED shows the status of the fans, the green light (OK) indicates that all fans work
fine and the red light (Fail) indicate that on or multiple fans are working abnormally.
PoE LED (1-8): The PoE LED lights up with solid green indicates power device is connected to corresponding
port. Solid amber indicates a PoE error has occurred at this port. And light off indicates this port is not
providing the power or no PD found.
Port Speed LED (1-8): The Port Speed LED lights up with solid green indicate the corresponding port is
running on 100M. Light off indicated that port is running on 10M.
3