Gas Hook-Up Instructions; Leak Testing Instructions - Napoleon Ultra Chef UP405 PEDESTAL Assembly Instructions Nstructions / Owners Manual

Gourmet grills

Table of Contents

Available languages

CYLINDER CONNECTION:

valve. Insert the black QCC1 regulator nipple onto the QCC1 fuel valve. Hand tighten clockwise. Do not use tools. Leak test all

joints prior to using the barbecue. A leak test must be performed annually, and each time a cylinder is hooked up, or if a part

of the gas system is replaced.

PROPANE CYLINDER INSTALLATION:

tank valve faces away from the barbecue. Lower the top tank mounting bracket onto the cylinder and tighten with wing nut.

IMPORTANT: Ensure that the hose is routed around the front side of the cart leg to maintain proper clearance to

the underside of the unit.

NATURAL GAS HOOK-UP:

designed for natural gas and certified for outdoor use. The gas grill is designed to operate at an inlet pressure of 7 inches water

column. A regulator must be installed if the house pressure is greater than 7 inches water column. Piping and valves upstream

of the quick disconnect are not supplied.

The quick disconnect must not be installed in an upward direction and a readily accessible manual shut-off valve must be installed

upstream of, and as close to, the quick disconnect as is feasible. The flared end of the hose must be connected to the unit as

illustrated in the Natural Gas Hose Attachment diagram. These connections must be made by a licensed gas installer. Leak test

all joints prior to using the gas grill.

IMPORTANT: Ensure that the hose is routed around the front side of the cart leg to maintain proper clearance to

the underside of the unit.

NON-SIDE BURNER UNITS:

tighten. (Do not use thread sealer/pipe dope.)

SIDE BURNER UNITS:

Attachment diagram. Connect the supply hose to the flare connection which faces down from the side burner. Tighten all

connections using two wrenches. (Do not use thread sealer/pipe dope.)

WARNING

• The installation must be performed by a licensed gas fitter, and all connections must be leak tested before operating the grill.

• Do not route hose underneath drip pan.

• Do not route hose between space in bottom shelf and back panel.

• Do not route hose over top of rear panel.

• Ensure all hose connections are tightened using two wrenches. Do not use teflon tape or pipe dope on any hose connection.

• Ensure the hose does not contact any high temperature surfaces, or it may melt and leak causing a fire.

• Leak test all the connections using a soap and water solution, as per the leak testing instructions found in this manual.

LEAK TESTING INSTRUCTIONS

DANGER

Do not use an open flame to check for gas leaks. Be sure there are no sparks or open flames in the area while you check for

leaks. Sparks or open flames will result in a fire or explosion, damage to property, serious bodily injury or death.

LEAK TESTING: This must be done before initial use, annually and whenever any gas components are replaced or serviced. Do

not smoke while performing this test, and remove all sources of ignition. See Leak Testing Diagram for areas to check.

1. Turn all burner controls to off. Turn supply valve on.

2. Brush a half and half solution of liquid soap and water onto all joints and connections of the regulator, hose, manifolds and

valves.

3. Bubbles will indicate a gas leak. Either tighten the loose joint or have the part replaced with one recommended by the customer

care department.

4. If the leak cannot be stopped, shut off the gas supply, disconnect it and have the barbecue inspected by your gas supplier or

dealer. Do not use the appliance until the leak has been corrected.

5. Turn off gas supply.