Dealing With Problems - Panasonic Touchbook CF-27 series Reference Manual

Dealing With Problems

When a problem occurs, please refer to this page. If you still cannot troubleshoot the problem, please contact Panasonic
Technical Support.
Starting Up
The power indicator or
battery indicator is not lit
or is displayed
[POST Startup Error(s)] is
displayed
The pre-memory count,
Windows star tup, or an
operation is extremely
slow
The date and time are
incorrect
When the previous item
is not the cause
Shutting Down
Unable to shut down win-
dows 95
Battery Indicator
The red indicator lights.
Repeated beeping sound
while the computer is in
use.
The red indicator blinks
After the AC adapter is
connected, the orange in-
dicator blinks five times
Check the cable connection for the AC adapter.
Check to see if a fully charged battery is properly installed.
Remove the battery pack and disconnect the AC adapter, then connect them again.
Please input your password. If you have forgotten it, contact Panasonic Technical
Support.
page 41
Press F9 in the Setup Utility (
settings to their default values (except the password settings). Then, the Setup Utility
must be run once again for you to input the appropriate operating environment settings.
(The processing speed depends on the application software used, so this operation may
not cause the processing speed to increase.)
You can set the date and time through [Date/Time] in [Start] - [Settings] - [Control
Panel].
If you continue to experience problems, the internal battery maintaining the clock
may need to be replaced. Please contact Panasonic Technical Support.
Press F9 in the Setup Utility (
settings to their default values (except the password settings).
Try removing all peripheral devices.
In the MS-DOS mode, run SCANDISK to check the hard disk.
At start-up, press F8
If a USB device is connected, try removing it.
The battery level is low. Save your data and power off your computer.
After connecting the AC adapter or replacing the battery pack with a fully charged
one, turn your computer on.
The battery pack or recharging function may be defective. Quickly remove the
battery pack and disconnect the AC adapter, then connect them again.
If the problem persists, contact Panasonic Technical Support.
Unable to charge because of an improper temperature range. (
tions")
page 33). This will restore the Setup Utility's
page 33). This will restore the Setup Utility's
to operate the computer in the Safe mode.
44
"Precau-