Technical Information - Panasonic Touchbook CF-27 series Reference Manual

Technical Information

Network
Hard Disk
The network connection may be severed when entering the ECO mode and suspend
(hibernation) mode. Be sure to disable the [Suspend/Hibernation Timeout] settings
with the Setup Utility if you require a network environment.
When the power saving function is running, communications software may malfunc-
tion. For example, communications may be halted if the suspend (hibernation) mode
is activated. The computer must be restarted if one of these modes is entered during
data communications.
Be sure that the computer enters the ECO mode or suspend (hibernation) mode
after the communications software is closed.
FAT32
This computer uses a new, highly efficient file system called FAT32. Please note the
following regarding FAT32.
Some software will not run normally:
Do not run disk utilities and other software not compatible with FAT32. Doing so
could cause incorrect information such as hard disk capacity to be shown or could
destroy hard disk data.
Contact Panasonic Technical Support or other outlet for the software and obtain the
latest version.
Non-recognition from other operating systems:
You will not be able to view the contents of your hard disk from other operating sys-
tems. (For example, you will not be able to view the contents of your hard disk even
when starting up using a floppy disk created with another computer.)
Other operating systems cannot therefore be installed. To install the operating sys-
tem, please refer to the method listed below. If you are unsure about this explanation,
do not proceed with installation of operating system.
1
Back up the contents of your hard disk.
2
Insert the FIRST AID FD, and restart the computer.
3
When the [Windows 95 Startup Menu] appears, select [1. Boot].
4
Input [FDISK], then press Enter .
When [Do you wish to enable large disk support (Y/N)...?] appears on the screen,
press N , then Enter .
5
Select [3. Delete partition or Logical DOS Drive].
6
Select [1. Delete Primary DOS Partition].
7
Start up again following the on-screen instructions.
These steps will allow you to install most operating systems.
The contents of the hard disk will be deleted. Always make sure to back up the hard
disk beforehand.
The following steps will normally be unnecessary, however, if installation is not pos-
sible, try performing them.
8
Start up again using the FIRSTAID FD to open FDISK in the same way.
9
When [Do you wish to enable large disk support (Y/N)...?] appears on the first
screen, press N , then
10
Select [1. Create DOS partition or Logical DOS Drive].
11
Set the partition following the on-screen instructions and activate it.
12
Start up again following the on-screen instructions.
Enter .
39