Panasonic Touchbook CF-27 series Reference Manual page 24

Using PC Card
PC Card Utility Program
About PhoenixCard Manager
CAUTION
If a ZV card does not operate properly, install PhoenixCard Manager
®
dows 95 by following the procedure below, after uninstalling the driver or the appli-
cation software for the card.
Otherwise, do not perform the installation; abnormal operation may result.
Installing
(only if the ZV card does not operate properly)
1
Set [Sound Controller] to [Auto] in the Setup Utility.
2
Select [Start] - [Run].
3
Type [c:\util\drivers\pccard\disk1\setup.exe], press [OK], then follow the on-screen
instructions.
CAUTION
After PhoenixCard Manager
power off the computer before installing or removing the card. Also, do not use
the suspend or hibernation functions if the card is installed.
NOTE
When running the power conservation function with the sound chip set,
there may be no sound output. In this case, the following setting needs to
be made.
In [Control Panel] - [Power] - [OPL3-SAx power management], set [Non Power
Save mode] then press [Apply]. Then press [OK]. (
Uninstalling
When you decide not to use the ZV card, be sure to perform the uninstall proce-
dure.
1
Uninstall PhoenixCard Manager
trol Panel] - [Add/Remove Programs].
2
Restart the computer.
3
Select [PC Card (PCMCIA)] in [Start] - [Settings] - [Control Panel].
4
Press [Next] at the display for the [Welcome to the PC Card (PCMCIA) Wizard],
press [Next] at the display for the [PC Card (PCMCIA) Wizard] and then press
[Finish].
5
Shut down the computer by following the on-screen instructions.
TM for Windows
TM ®
for Windows 95 has been installed, make sure to
TM ®
for Windows 95 in [Start] - [Settings] - [Con-
® 95
TM for Win-
page 40)
24