Operating Instructions; Glass Information; Louvre Removal; Window Frame Assembly Removal - Majestic fireplaces 360DVS2 Homeowner's Installation And Operating Manual

Multisided top/rear vent convertible direct vent
Table of Contents

Advertisement

360 DVS Series Direct Vent Fireplaces

Glass Information

Only glass approved by CFM Corporation
should be used on this fireplace.
The use of any non-approved replacement glass will
void all product warranties.
Care must be taken to avoid breakage of the glass.
Do not operate appliance with glass front
removed, cracked or broken.
Replacement glass (complete with gasket) is
available through your Majestic Fireplaces
dealer and should only be installed by a licensed
qualified service person.
�������

Louvre Removal

The top side and top end
louvres are removed by simply
lifting the louvre assembly and
pulling the assembly away
from the fireplace. (Fig. 36)
The lower side louvres are
hinged along there lower
edge and are folded down for
access to components in the
base cavity of the fireplace.
The lower end louvre assembly
on the 360DVS3/ SL/ SR units
is removed in the same man-
ner as the top louvre assem-
blies.

Window Frame Assembly Removal

Side Window Frame Assemblies
1. Shut off the gas supply.
2. Allow the fireplace to cool if it has been in operation.
3. Remove the top louvre assembly.
4. Lower the bottom louvre assembly.
5. Release the two clamps along lower edge of the
frame by pulling down on clamp handles. (Fig. 37)
6. Tilt lower edge of frame out slightly and lift window
frame assembly up and away from the fireplace.
24

Operating Instructions

��� ����� ����
����� ������
�� ��� ����� �����
����� �������
����� ����� ��������
�� ����� ������
Figure 36
2.
Louvre
1.
Glass Panel
FP1227
FP1227
Louvre removal
11/02
7. To reinstall the window frame assembly reverse
this procedure.
Front Window Frame Assembly
1. Remove the top and bottom louvre assembly.
2. Remove the lower window trim (held in place with
magnets).
3. Remove both lower retaining screws. Access to
these screws is gained through the holes along the
lower edge of the frame behind the trim. (Fig. 38)
4. Tilt lower edge of frame out slightly and lift window
frame assembly up and away from the fireplace.
5. To reinstall the window frame assembly reverse
the process.
Window
Frame
Assembly
Fig. 37 Window frame assembly removal.
FP1228
remove glass frame
11/02
Location of Lower
Retaining Screws
Fig. 38 Retaining screw.
Remove_end_glass&frame
360DVS
rev. -9-17-02
rjs
Lower Clamps
Window
Frame
Assembly
Pull Clamp
Push
Hook
Clamp
Han-
dle
FP1228
FP1445
10006326

Hide quick links:

Advertisement

Table of Contents
loading

This manual is also suitable for:

360dvsl360dvs3360dvsr360dvs3360dvsl360dvsr

Table of Contents