Table of Contents
Advertisement
Glass Information
Only glass approved by CFM Corporation
should be used on this fireplace.
•
The use of any non-approved replacement glass will
void all product warranties.
•
Care must be taken to avoid breakage of the glass.
•
Do not operate appliance with glass front
removed, cracked or broken.
•
Replacement glass (complete with gasket) is
available through your CFM Corporation dealer
and should only be installed by a licensed
qualified service person.
�������
�
Louvre Removal
To remove the lou-
vre top assembly,
lift louvre up and
then out. (Fig. 12)
The louvre bottom
assembly is hinged
at the bottom edge
and swings down.
Fig. 10 Louvre install and removal.
Window Frame Assembly Removal
1. Turn gas off.
2. Let the unit cool if it has been operating.
3. Remove louvre top assembly. (Refer to Louvre Re-
moval section.)
4. Open louvre bottom assembly.
5. Release the two clamps at the bottom of the window
frame by pulling down on the clamp handles.
6. Lift off the window frame assembly as shown. (Fig.
11)
7. To reinstall window frame assembly, follow the
above procedure in reverse.
20000194
Operating Instructions
��� ����� ����
����� ������
�� ��� ����� �����
����� �������
����� ����� ��������
�� ����� ������
2.
Louvre
1.
Top
Assembly
Glass Panel
FP383
GF383 NVC
11/20/96
REMOVE LOUVRE/GRILLE
Window
Frame As-
sembly
Fig. 11 Window frame assembly removal.
Glass Cleaning
It is necessary to clean the glass periodically. Dur-
ing start-up, condensation, which is normal, forms on
the inside of the glass and causes lint, dust and other
airborne particles to cling to the glass surface. Also
initial paint curing may deposit a slight film on the glass.
It is therefore recommended the glass be cleaned two
or three times with a non-ammonia household cleaner
and warm water (gas fireplace glass cleaner is recom-
mended). After initial use glass should be cleaned two
or three times during heating season.
Clean glass after first two weeks of opera-
tion.
Do not clean glass when hot.
Do not use abrasive cleaners.
Do not strike or slam the glass.
Log Installation
1
. Remove window frame assembly. (Refer to Page xx)
2. Remove logs from the packaging.
As with all plastic, these bags are not toys
and should always be kept away from chil-
dren and infants.
3. Place rear log on back bracket. Ensure that log is
firmly positioned and there is no side-to-side move-
ment.
4. Place the front log on top of the burner, use bottom
holes to locate the logs on top of the studs.
5. Place the front right log on top of the burner, Use
bottom holes to locate the logs on top of the studs.
NVC Series B-Vent
Lower
Clamps
Window Frame
Assembly
Pull Clamp
Push
Hook
Clamp
Handle
FP1191
11
Hide quick links:
Advertisement
Table of Contents
