Table of Contents
Advertisement
37
Specifications/Notes
....
e
,J
Hooking
Up Your VCR
If the reception on all channels is poor,
you may need to tune your TV set again.
" • If the power fails for more than one
:
minute, programmed timer recordings
:
may be lost.
i
• It is best to finish programming a timer
recording at least five minutes before
i
the recording is scheduled to begin.
i
• If, after programming a timer record-
i
ing, you turn the VCR power off with-
:
out putting a tape in the VCR, the
Timer light will blink.
i
• If the record tab on a tape is missing,
i
the VCR will eject the tape. The
i
Timer light will blink.
:
• 12 PM is noon; 12 AM is midnight.
Timer
Recording
Power Failure
Timer recordings and the time may be
lost if the power fails for more than one
minute.
i Satellite
Hookups
: • Watching one TV channel while
:
recording another may not be possible
!
if you have a satellite hookup.
: • You may have to set your TV to chan-
t
:
nel 3 or 4, then make your channel
:
selections at the satellite'converter
!
box.
i • With many satellite hookups, if you
e
:
use accessory audio and video cables
"-
to connect your VCR to your TV, you
i
will have to program your VCR to
"
accept line input. To enter Line Input
"-
mode, press O, O, 1 (if audio/video
•
cables are connected via the AUDIO
:
and VIDEO IN(put) jacks on the rear
:
of the VCR), or 0, 0, 2 (if audio/video
:
cables are connected via the AUDIO
e
:
and VIDEO (Input) jacks on the front
"
of the VCR). AV REAR or AV
:
FRONT will appear on your TV screen
:
briefly.
Line Input
If you accidentally enter Line Input
mode (AV REAR or AV FRONT will
appear on your TV screen briefly), press
the CHANNEL (Up/Down) buttons or
use the Number buttons to select another
channel.
Daylight-Saving
Time
When automatic daylight saving time is
set, the clock time will change automati-
cally as follows: on the first Sunday in
April, 2:00 AM to 3:00 AM; on the last
Sunday in October, 2:00 AM to 1:00
AM.
• During the April time change, a timer
recording programmed to start between
2:00 AM and 2:59 AM will not record.
A timer recording programmed to end
between 2:00 AM and 2:59 AM will
end when the clock moves forward
(2:00 AM).
• During the October time change, a
recording cannot be started between
the second 1:00 AM and 1:59 AM.
Advertisement
Table of Contents
