Specifications/Notes - Magnavox VRU364AT Owner's Manual

45
Specifications/Notes
_75ohms u_balanced
_41°F (5°C) to 104°F
t0% to 80%
VHF 2-13, UHF 14-69
Midband: A-I
Special Channel! 5A
Ultraband: 37 - 94, ....
subject to change without :
Hooking Up Your VCR
If the reception on all channels is poor,
you may need to tune your TV set again.
Timer Recording
• It is best to finish programming a timer
recording at least five minutes before
the recording is scheduled to begin.
• If, after programming a timer record-
ing, you turn the VCR power off with-
out putting a tape in the VCR, the
Timer light will blink.
• If the record tab on a tape is missing,
the VCR will eject the tape. The Timer
light will blink.
• 12 PM is noon; 12 AM is midnight.
Power Failure
Timer recordings may be lost if the
power fails for more than one minute.
When you use the VCR with the auto
clock function set to OFF, the clock set-
ting may be lost. Follow the steps on
page 10.
Satellite Hookups
• Watching
one TV channel while
recording another may not be possible
if you have a satellite hookup.
• You may have to set your TV to chan-
nel 3 or 4, then make your channel
selections at the satellite converter box.
• With many satellite hookups, if you use
accessory audio and video cables to
connect your VCR to your TV, you will
have to put your VCR in Line Input
mode. To enter Line Input mode, press
0, 0. A/V IN will appear on your TV
screen briefly.
Line Input
If you accidentally enter Line Input mode
(A/V IN will appear on your TV screen
briefly), press the CHANNEL
(Up/Down) buttons or use the Number
buttons to select another channel.
Daylight-Saving Time
When automatic Daylight-Saving Time is
set, the clock time will change automati-
cally as follows: on the first Sunday in
April, from 2:00 AM to 3:00 AM; on the
last Sunday in October, from 2:00 AM to
1:00 AM.
• During the April time change, a timer
recording programmed to start between
2:00 AM and 2:59 AM will not record.
A timer recording programmed to end
between 2:00 AM and 2:59 AM will
end when the clock moves forward
(2:00 AM).
• During the October time change, a
recording cannot be started between
the second 1:00 AM and 1:59 AM.
Hi-Fi Stereo Sound
• During playback, Hi-Fi audio may ten]-
porarily revert to normal audio when
you adjust tracking. This is normal.
• When connecting the VCR to a stereo
TV, you will only get stereo sound if you
use audio cables to connect the audio out-
put jacks on the VCR to the audio input
jacks on your TV, and if the TV is in Line
(Auxiliary) Input mode.
• When you connect the audio output
jacks on the VCR to the audio input
;jacks on your TV, the stereo light on the
TV might not glow. But, as long as the
status display indicates a stereo signal,
you are receiving a stereo signal. This
is normal.
• If Hi-Fi audio continually reverts to
normal audio during playback, you
may want to change AUDIO OUT to
MONO at step 4 on page 37.
• Only tapes recorded in Hi-Fi audio will
play back in Hi-Fi audio. Tapes
recorded in normal audio will play
back in monaural audio.