Jayco 2016 EAGLE User Manual page 64

JAYCO TOWABLE
3. Most slideout switches are located on the monitor panel or on the wall. To move the
room out, press the OUT section of the switch and hold it until the motor stops (travel
time is approx. 25 seconds). Operating the switch after the room is fully extended will
damage the switch and motor. Some models may be equipped with a wireless remote
control to operate the slideout. To operate the slideout using the remote, press the
on/off button to power on the remote. Select the slideout you want to operate by
pressing the corresponding button. Next, press and hold the (extend/retract) arrow
button to move the room in or out.
press the on/off button once more to power off the remote.
NOTE: Do not operate the switch after the room is fully extended as damage can
occur to the motor and/or switch.
Slideout remote
control
4. After the slideout is extended, verify
that the corners of the black rubber
seal are set up correctly. The corners
of this seal are cut at a 45° angle. The
top of the seal must overlap the side of
the seal to avoid the possibility of
water penetration.
5. Retracting slideout room
Press the IN section of the slideout control switch and hold it until the motor
stops. Operating the switch after the room is fully retracted will damage the
switch and motor.
Maintenance
Do not work on your system unless the 12-volt DC (auxiliary battery, customer
supplied) and 120-volt AC electrical systems (shore line power cord) have been
disconnected.
Your slideout system has been designed to require very little maintenance. To ensure a
long life of your slideout system, read, understand and follow these simple instructions.
This system contains a pre-lubed bearing that is lubricated when the room is moved in and
out. Do not spray oil or grease on the rails while the room is extended.
SECTION 5-SLIDEOUT SYSTEMS
When you are finished moving the slideout,,
Slide room switches
on monitor panel
WARNING
5-2
Slideout Wall
Switch
Exterior slideout
room corner