Table of Contents
Advertisement
JAYCO TOWABLE
followed by the Enter button. The system will provide four short beeps to indicate new
code acceptance. This new code will now activate the lock.
To reset the code, remove the batteries for at least 10 seconds. Re-install the batteries; and
follow the steps to Programming New Code.
System Fault Logic:
Action
Ready to Accept New Code
New Code Entered
Wrong Code Entered
Dead Bolt Locks
Dead Bolt Unlocks
Dead Bolt fails to Lock
Dead Bolt fails to Unlock
Low Battery
The lock will cycle up to 10 more times once the low battery indication occurs. After this
the final electric function in a low battery condition will be unlock and will not lock until
the batteries have been replaced. Please note that if the deadbolt is in the locked position
and the batteries die the deadbolt will remain locked. The key will always be able to
activate the deadbolt lock.
Please enter your Personal Code to prevent inadvertent programming
General Maintenance and Operating Guidelines
Install fresh batteries as necessary. The lock is designed to function for months of
normal usage with fresh, high quality AA batteries. Battery life is highly dependent
upon battery quality, usage, and environment (temperature).
Make sure there are no obstructions in the door frame to prevent Dead Bolt extension.
Do not wash with power washer or high pressure cleaner. The lock is designed to
resist water intrusion to protect its electrical components from normal water
encounter such as rain.
The lock uses Touch Technology. The buttons are activated by touching not pressing.
Remove batteries when storing or not using this lock for extended periods of time.
(Note: the factory code will reset when the batteries are removed for longer than 10
seconds)
SECTION 4-TOWING & SET-UP
Response
Three short beeps
Four short beeps
One long beep
Two short beeps
Two short beeps
One long beep
One long beep
One Long beep after the Lock/Unlock beeps
4-8
Advertisement
Table of Contents
