Troy-Bilt Super Bronco Operator's Manual page 18

4. Remove all dirt and clean the area around the transmission
cover. See Fig. 7-3.
Hex Screw
Transmission
Cover
5. Remove the four hex screws (
transmission cover to the drive shaft and remove the cover.
See Fig. 7-3.
6. Remove the left-side wheel. Tilt the left-side wheel shaft
into a drain pan and allow the gear oil to drain through the
top of the transmission.
7. Reinstall the wheel and reinstall the transmission cover.
8. Refill the transmission using
Refill the engine with motor oil and replenish the fuel tank
with gasoline.
9. Reinstall the belt cover.
18 s 7— s
ectiOn ervice
Transmission
Housing
Figure 7-3
5⁄16-18 x .75) securing the
Mobil 1® Synthetic 75W 140.