Lights/Instruments/Switches - KYMCO Agility 125 Service Manual

17

. LIGHTS/INSTRUMENTS/SWITCHES

17
SERVICE INFORMATION ................... 17-0
TROUBLESHOOTING .......................... 17-0
FUEL UNIT .............................................. 17-1
HANDLEBAR SWITCHES.................... 17-2
SERVICE INFORMATION
GENERAL INSTRUCTIONS
• An electric tester is needed to measure or test the electric equipment.
• Be sure to use fuses and bulbs of the same specifications to avoid damage of electrical
equipment.
• After installation of each switch, a continuity check must be performed. A continuity check can
usually be made without removing the part from the motorcycle.
TROUBLESHOOTING
Lights do not come on when ignition
switch is "ON"
• Burned bulb
• Faulty switch
• Broken wire
• Fuse burned out
• Weak battery
• Poorly connected or shorted wire
• Faulty winker
Light dims
• Faulty ignition coil
• Wire or switch resistance too high
• Faulty regulator/rectifier
Headlight does not change when dimmer
switch is turn to Hi or Lo
• Faulty or burned bulb
• Faulty dimmer switch
IGNITION SWITCH ............................ 17-3
STOP SWITCHES/HORN ................... 17-4
INSTRUMENTS.................................... 17-4
HEADLIGHT/LIGHTS........................ 17-5
Fuel gauge pointer does not register
correctly
• Disconnected wire or connector
• Broken wire
• Faulty float
• Faulty fuel unit
• Faulty instrument
Fuel gauge pointer fluctuates or swings
• Loose wire connection
• Faulty fuel unit
• Faulty instrument
AGILITY 125
17
17-0