KYMCO Agility 125 Service Manual page 157

14
. BATTERY/CHARGING SYSTEM/
A.C. GENERATOR
A.C. GENERATOR CHARGING
COIL
＊
The inspection of A.C. generator charging
coil can be made with the engine installed.
INSPECTION
Disconnect the A.C. generator 2P connector.
Measure the resistance between the A.C.
generator white wire and engine ground with
an electric tester.
Standard: 0.2～1.2Ω(at 20℃)
Replace the A.C. generator charging coil if
the reading is not within the specifications.
A.C. GENERATOR LIGHTING
COIL
＊
The inspection of A.C. generator lighting
coil can be made with the engine installed.
INSPECTION
Disconnect the A.C. generator 2P connector.
Measure the resistance between the A.C.
generator yellow wire and engine ground
with an electric tester.
Standard: 0.1～1.0Ω (20℃)
Replace the A.C. generator lighting coil if the
reading is not within the specifications.
RESISTOR INSPECTION
Remove the front covers. ( 2-2)
Measure the resistance between the resistor
lead and engine ground.
Resistances: 5W12Ω: 11～13Ω
30W7.5Ω: 6～8Ω
A.C. GENERATOR
REMOVAL
Remove the right side cover. ( 2-4)
Remove the four bolts attaching the cooling
fan cover to remove the fan cover.
Charging Coil Wire
Lighting Coil Wire
Fan Cover
AGILITY 125
Resistor
14-6