ZyXEL Communications GS3700 Series User Manual page 69

Figure 35 Basic Setting > PoE Status (Stacking mode)
The following table describes the labels in this screen.
Table 16 Basic Setting > PoE Status
LABEL DESCRIPTION
PoE Status
Slot (Stacking mode) This field appears only in stacking mode. Click the drop-down list to choose the slot
number of the Switch in a stack.
PoE Mode This field displays the power management mode used by the Switch, whether it is in
Classification or Consumption mode.
Total Power This field displays the total power the Switch can provide to the connected PoE-enabled
devices on the PoE ports.
Consuming Power This field displays the total amount of power the Switch is currently supplying to the
(W) connected PoE-enabled devices.
Allocated Power (W) This field displays the total amount of power the Switch has reserved for PoE after
negotiating with the connected PoE device(s).
Consuming Power (W) can be less than or equal but not more than the Allocated
Power (W).
Remaining Power This field displays the amount of power the Switch can still provide for PoE.
(W)
Note: The Switch must have at least 16 W of remaining power in order to supply power
Port (standlaone and This is the port index number.
stacking mode)
State This field shows which ports can receive power from the Switch. You can set this in the
Basic Setting > PoE Setup screen.
•
•
Chapter 6 Basic Setting
to a PoE device, even if the PoE device needs less than 16 W.
Disable - The PD connected to this port cannot get power.
Enable - The PD connected to this port can receive power.
GS3700/XGS3700 Series User's Guide
69