Problem
The message 'NO SIGNAL'
appears.
The message 'Recording of
<XX> will start within 1
minute' appears.
The message 'Insert
recordable disc' appears.
The message 'Maximum
number of timers reached'
appears.
The message 'Collision'
appears.
MRV660_17_Eng40
Troubleshooting
Solution
– Check that the cable is plugged in firmly.
– If a recording is made from a video recorder, change the tracking
on the video recorder.
– The DVD recorder may not be able to recognize the video input
signal if this signal is poor or does not comply with relevant
standards.
–
Select { Switch now } to switch the DVD recorder to standby
mode. A programmed timer recording will only start recording if
the DVD recorder is in standby mode.
–
Select { Suspend } will suspend the timer recording.
–
Select { Cancel recording } will cancel the timer recording.
–
Either no disc was inserted or a disc was inserted that cannot
be used for recordings. Insert a disc that can be recorded upon.
Locate on the disc the right position for the recording. Press
STOP button. Turn off the DVD recorder by pressing
STANDBY-ON button.
–
It has reached the maximum programmed, no more recordings
are allowed. Press TIMER button, select the programmed
recording (TIMER block) you want to check or clear using 3 4
button.
–
The timer recording overlaps with another timer recording.
–
If you ignore this warning, the programmed recording with the
early start time will start first.
The second recording will then lack the beginning.
–
Change the information for one of the two recordings.
–
Delete one of the two recordings.
65
(cont'd)
3139 246 XXXXX
9/3/05, 10:26 AM
65