Getting Started; Step 1: Inserting Batteries Into The Remote Control; Using The Remote Control To Operate The System; Step 2: Setting The Tv - Magnavox MRD130 User Manual

Step 1: Inserting batteries
into the remote
control
1
Open the battery compartment.
2
Insert two batteries type R06 or AA,
following the indications (+-) inside
the compartment.
3
Close the cover.
Using the remote control to
operate the system
1
Aim the remote control
directly at the remote
sensor (iR) on the front
panel.
2
Select the source you
wish to control by
pressing one of the
source select buttons on
the remote control (for
example TV, TUNER.)
3
Then select the desired
function (for example
ÉÅ, S, T .)
CAUTION!
– Remove batteries if they are
exhausted or if the remote is not to
be used for a long time.
– Do not use old and new or
different types of batteries in
combination.
– Batteries contain chemical
substances, so they should be
disposed of properly.

Getting Started

Step 2: Setting the TV

IMPORTANT!
Make sure you have completed all
the necessary connections. (See pages
10–11 "Connecting TV".)
1
Press SOURCE control until "DISC"
appears on the display panel (or press
DISC on the remote.)
2
Turn on the TV and set to the correct
video-in channel. You should see the blue
DVD background screen on the TV.
➜
Usually this channel is between the
lowest and highest channels and may be
called FRONT, A/V IN, or VIDEO. See
your TV manual for more details.
➜
Or, you may go to channel 1 on your
TV, then press the Channel down button
repeatedly until you see the Video In
channel.
➜
Or, the TV remote control may have a
button or switch that chooses different
video modes.
➜
Or, set the TV to channel 3 or 4 if you
are using an RF modulator.
17