Subaru 2004 LEGACY Service Manual page 193

Diagnostic Procedure with Diagnostic Trouble Code (DTC)
ENGINE (DIAGNOSTICS)
Step
2 CHECK POOR CONTACT.
Check poor contact in connector between
ECM and accelerator position sensor.
3 CHECK HARNESS BETWEEN ECM AND AC-
CELERATOR POSITION SENSOR.
1) Turn the ignition switch to OFF.
2) Disconnect the connector from ECM.
3) Disconnect the connector from the acceler-
ator position sensor.
4) Measure the resistance between ECM con-
nector and accelerator position sensor connec-
tor.
Connector & terminal
(B136) No. 17 — (B315) No. 5:
(B136) No. 15 — (B315) No. 3:
(B136) No. 28 — (B315) No. 2:
(B136) No. 16 — (B315) No. 1:
4 CHECK HARNESS BETWEEN ECM AND AC-
CELERATOR POSITION SENSOR.
Measure the resistance between ECM connec-
tor and chassis ground.
Connector & terminal
(B136) No. 17 — Chassis ground:
(B136) No. 15 — Chassis ground:
(B136) No. 28 — Chassis ground:
(B136) No. 16 — Chassis ground:
5 CHECK POWER SUPPLY OF ACCELERA-
TOR POSITION SENSOR.
1) Connect the ECM connector.
2) Turn the ignition switch to ON.
3) Measure the voltage between accelerator
position sensor connector and engine ground.
Connector & terminal
(B315) No. 3 (+) — Engine ground (
(B315) No. 1 (+) — Engine ground (
6 CHECK ACCELERATOR POSITION SEN-
SOR.
Measure the resistance of accelerator position
sensor.
Terminals
No. 3 — No. 4:
7 CHECK ACCELERATOR POSITION SEN-
SOR.
Measure the resistance of accelerator position
sensor.
Terminals
No. 1 — No. 6:
8 CHECK ACCELERATOR POSITION SEN-
SOR.
Measure the resistance of accelerator position
sensor without depressing the accelerator
pedal.
Terminals
No. 5 — No. 4:
Check
Is there poor contact?
Is the resistance less than 1
Ω?
Is the resistance more than 1
MΩ?
Is the voltage 4.5 — 5.5 V?
−
):
−
):
Is the resistance 1.2 — 4.8
kΩ?
Is the resistance 0.75 — 3.15
kΩ?
Is the resistance 0.2 — 0.8
kΩ?
EN(H6DO)(diag)-262
Yes
Repair the poor Go to step 12.
contact.
Go to step 4. Repair the open
circuit of harness
connector.
Go to step 5. Repair the ground
short circuit of har-
ness.
Go to step 6. Repair the poor
contact in ECM
connector.
Replace the ECM
if defective. <Ref.
to FU(H6DO)-34,
Engine Control
Module (ECM).>
Go to step 7. Replace the accel-
erator position
sensor.
Go to step 8. Replace the accel-
erator position
sensor.
Go to step 9. Replace the accel-
erator position
sensor.
No