Subaru 2004 LEGACY Service Manual page 11

Diagnostic Procedure with Diagnostic Trouble Code (DTC)
ENGINE (DIAGNOSTICS)
Step
1 CHECK OUTPUT SIGNAL FROM ECM.
1) Turn the ignition switch to ON.
2) Measure the voltage between ECM con-
nector and chassis ground.
Connector & terminal
(B134) No. 2 (+) — Chassis ground (
(B134) No. 3 (+) — Chassis ground (
2 CHECK FRONT OXYGEN (A/F) SENSOR
HEATER CURRENT.
1) Turn the ignition switch to OFF.
2) Repair the battery short circuit in harness
between ECM and front oxygen (A/F) sensor
connector.
3) Turn the ignition switch to ON.
4) Read the data of front oxygen (A/F) sensor
heater current using Subaru Select Monitor.
NOTE:
For detailed operation procedures, refer to the
"READ CURRENT DATA SHOWN ON DIS-
PLAY FOR ENGINE". <Ref. to EN(H6DO)(di-
ag)-25, Subaru Select Monitor.>
3 CHECK OUTPUT SIGNAL FROM ECM.
Measure the voltage between ECM connector
and chassis ground.
Connector & terminal
(B134) No. 2 (+) — Chassis ground (
(B134) No. 3 (+) — Chassis ground (
Check
Is the voltage more than 8 V?
−
):
−
):
Is the current more than 2.3 A? Replace the ECM.
Does the voltage change by
shaking the ECM harness and
connector?
−
):
−
):
EN(H6DO)(diag)-80
Yes
Go to step 2. Go to step 3.
END.
<Ref. to
FU(H6DO)-34,
Engine Control
Module (ECM).>
Repair the battery END.
short circuit in har-
ness between
ECM and front
oxygen (A/F) sen-
sor connector.
No