Subaru 2004 LEGACY Service Manual page 132

Diagnostic Procedure with Diagnostic Trouble Code (DTC)
Step
6 CHECK HARNESS BETWEEN EGR SOLE-
NOID VALVE AND ECM CONNECTOR.
1) Turn the ignition switch to OFF.
2) Detach the connector from EGR solenoid
valve and ECM.
3) Measure the resistance of harness
between EGR solenoid valve and ECM con-
nector.
Connector & terminal
(B134) No. 8 — (E18) No. 6:
(B134) No. 10 — (E18) No. 1:
(B134) No. 9 — (E18) No. 4:
(B134) No. 11 — (E18) No. 3:
7 CHECK HARNESS BETWEEN EGR SOLE-
NOID VALVE AND ECM CONNECTOR.
Measure the resistance of harness between
EGR solenoid valve and chassis ground.
Connector & terminal
(B134) No. 8 — Chassis ground:
(B134) No. 9 — Chassis ground:
(B134) No. 10 — Chassis ground:
(B134) No. 11 — Chassis ground:
8 CHECK POOR CONTACT.
Check the poor contact in ECM and EGR sole-
noid valve connector.
Check
Is the resistance less than 1
Ω?
Is the resistance more than 1
MΩ?
Is there poor contact in ECM or
EGR solenoid valve connec-
tor?
EN(H6DO)(diag)-201
ENGINE (DIAGNOSTICS)
Yes
Go to step 7. Repair the open
circuit in harness
between ECM and
EGR solenoid
valve connector.
Go to step 8. Repair the short
circuit in harness
between main
relay and EGR
solenoid valve
connector.
Repair the poor Even if the mal-
contactrepair the function indicator
poor contact in light illuminates,
ECM and EGR the circuit has
solenoid valve returned to a nor-
connector. mal condition at
this time.
No