Reclining The Seat; Reclining The Leg Rest; Removing The Seatcover; Attaching The Bumper Bar - CYBEX Callisto User Manual

10. reclining the seat

a)
Pull the recline lever at the back of the seat in order to recline the backrest to
one of the 5 different positions.
b) To raise the seat lift the complete backrest up to the required position.

11. reclining the leg rest

a) Press the leg rest on both front edges and push it down.
b)
Lift the leg rest to return it to the starting position.

12. removing the seatcover

• Slightly fold the stroller to reduce tension.
• Remove the canopy and bumper bar from the stroller, if attached.
• Remove the seat cover hooks from both sides of the frame (Nr. 1, fig. 12).
• Open the press studs of the two straps connecting the seat side panels with
the rear tube (Nr. 2, fig. 12).
• Open the flaps which are fixed with fasteners covering both sides of the seat
tube fixed underneath the seat unit (Nr. 3, fig. 12).
• Feed the strap with the slider of the central harness buckle through the hole in
the seat fabric. Release the belt lock under the seat fabric.
• Release the loops located at the end of the shoulder straps from the metal
triangle attached to the belt system. The triangle is situated at the bottom of
the backrest underneath the seat cover (see fig. 9a).
• Remove the shoulder straps from the holes of the backrest and the fabric seat
cover (see fig. 9b).
• Lift the leg rest up and slide the fabric down the seat unit after opening the
fastener velcro.
• Slide the fabric off the seat base tubes.
• Reverse this procedure to refit the seat cover and the harness. Ensure that
the seat tubes slide back into the pockets inside the seat cover
6

13. attaching the bumper bar

To attach the bumper bar slide the left and right bumper bar connectors into
the adapter located inside the seat fabric pocket. Press the buttons on the left
and right side of the bumper bar to remove it.

14. Carrying the stroller

Pull the flexible carrying handle on the middle rear tube and lift to carry the
stroller.

15. attaching the raincover (optional)

Extend the raincover over the stroller as shown in the image. To fit the
raincover fasten the fastener strips around the frame at the top and bottom on
both sides of the buggy.

16. Warranty

1.1 Our goods come with guarantees that cannot be excluded under the Australian
Consumer Law. You are entitled to a replacement or refund for a major failure and
compensation for any other reasonably foreseeable loss or damage. You are also
entitled to have the goods repaired or replaced if goods fail to be of acceptable quality
and the failure does not amount to a major failure.
1.2 in addition to the guarantees that cannot be excluded under the Australian
Consumer Law described in clause 1.1 and any other guarantee or warranty implied by
law, when you purchase one of our products, you will also have the peace of mind in
knowing that your product is covered by CNP Brands Standard Warranty. The Standard
Warranty is provided by C.O. White Pty Ltd trading as CNP Brands (ABN 97 004 169
233) ("CNP Brands"). The terms and conditions of the Standard Warranty are further
described below.
1.3 Subject to clause 1.1 and the terms below, CNP Brands warrants that this CNP
Brand product, purchased by you in Australia or New Zealand:
a) is free from defects in workmanship and material, when the product is used
for normal consumer use for a period of 2 years from the date of purchase
as evidenced by your proof of purchase ("Warranty Term"); and