Dodge 2016 Dart User Manual page 43

O P E R A T I N G Y O U R V E H I C L E
To Set A Desired Speed
Turn the Electronic Speed Control ON.
NOTE:
The vehicle should be traveling at a steady speed and on level ground before pushing
the SET button.
When the vehicle has reached the desired speed, push the SET (-) button and release.
Release the accelerator and the vehicle will operate at the selected speed.
NOTE:
After pushing the SET button "Cruise Control Set" message is displayed for five sec-
onds or until another switch is pushed.
For Premium Clusters Only
• When set to analog mode: The red outer line on the speedometer changes from red to
white to identify set speed.
To Deactivate
A soft tap on the brake pedal, pushing the CANCEL button, or normal brake pressure while
slowing the vehicle will deactivate Electronic Speed Control without erasing the set speed
memory. Pushing the ON/OFF button or turning the ignition switch OFF erases the set
speed memory.
NOTE:
After pushing the OFF button a "Cruise Control Off" message is displayed for five sec-
onds or until another switch is pushed.
For Premium Clusters Only
• When set to analog mode: The white outer line on the speedometer returns to red.
To Resume Speed
To resume a previously set speed, push the RES (+) button and release. Resume can be
used at any speed above 20 mph (32 km/h).
41