Kärcher K 3.47 M Operator's Manual
Kärcher K 3.47 M Operator's Manual

Kärcher K 3.47 M Operator's Manual

High pressure washer
Hide thumbs Also See for K 3.47 M:

Advertisement

K 3.47 M
English
Español
Français
5.962-605.0
2
18
35
01/08

Advertisement

Table of Contents
loading

Summary of Contents for Kärcher K 3.47 M

  • Page 1 K 3.47 M English Español Français 5.962-605.0 01/08...
  • Page 2: Table Of Contents

    Kärcher Customer Support MODEL OVERVIEW Mexico 4 - 5 IMPORTANT SAFETY INSTRUC- TIONS Call: 01-800-024-13-13 for help or visit ASSEMBLY INSTRUCTIONS our website: www.karcher.com.mx 6 - 7 OPERATING INSTRUCTIONS USING THE ACCESSORIES Safety Alert Symbols 8 - 9 WORKING WITH DETERGENTS DANGER TAKING A BREAK indicates “an imminently hazardous sit-...
  • Page 3: Model Overview

    MODEL OVERVIEW 1 Power cord with Ground Fault Circuit 10 High pressure outlet Interrupter (GFCI) 11 ON/OFF switch 2 Trigger gun 12 Vario Power Spray wand 3 Trigger gun safety lock 13 Dirtblaster® (Rotary spray wand) 4 High pressure hose CAUTION 5 Water inlet with garden hose con- This unit has been designed for use with...
  • Page 4: Important Safety Instruc

    IMPORTANT SAFETY INSTRUCTIONS WARNING! physical injuries to the operator and When using this product basic irreversible damage to the machine. precautions should always be To reduce the risk of electrocution, followed, including the following: keep all connections dry and off the Read all the instructions before us- ground.
  • Page 5 grounding plug. The plug must be WATER SUPPLY plugged into an appropriate outlet that is (Cold Water Only) properly installed and grounded in ac- cordance with all local codes and ordi- CAUTION nances. When connecting the water inlet to the water supply mains, local regulations of DANGER your water company must be observed.
  • Page 6: Assembly Instructions

    ASSEMBLY INSTRUCTIONS STEP 3: Required tools A Philips Screwdriver, medium size (not supplied) for final assembly STEP 1, 2: STEP 4, 5: OPERATING INSTRUCTIONS STEP 1: STEP 2: Connect the high pressure hose to Insert the spray wand of your choice the unit’s high pressure outlet.
  • Page 7 STEP 3: WARNING Connect garden hose to unit’s water Do not use if above test fails. inlet. STEP 6: Unlock the trigger gun safety lock. STEP 4: Trigger the gun to eliminate trapped Connect garden hose to the cold wa- air, wait for a steady flow of water to ter source and turn water on com- emerge from the spray nozzle.
  • Page 8: Using The Accessories

    USING THE ACCESSORIES To apply detergent, the wand must WARNING be positioned to the lower pressure To avoid serious injury never point setting (Mix). spray nozzle at yourself, other per- sons or animals. Dirtblaster® Always test an inconspicuous area This nozzle features a 0º pencil jet before cleaning with high pressure.
  • Page 9: Taking A Break ..Five Minutes Or More

    STEP 3: Always Use Kärcher Detergent for Turn on the pressure washer (I). Pull Best Results trigger to operate unit. Liquid deter- Kärcher biodegradable detergents are gent is drawn into the unit and mixed specially formulated to protect the envi- with water.
  • Page 10: Shutting Down & Clean-Up

    SHUTTING DOWN & CLEAN-UP STEP 1: STEP 5: Turn the switch to OFF (0) position Disconnect the garden hose from and unplug cord from outlet. the water inlet on the unit. STEP 2: Turn off the water source. STEP 6: STEP 3: Disconnect the high pressure hose Press trigger to release water pres-...
  • Page 11: Winterizing And Long-Term

    WINTERIZING AND LONG-TERM STORAGE 1: Disconnect all water connections. of heat as it may dry out the pump seals. 2: Turn on the machine for a few seconds, until the water which had CAUTION remained in the pump exits, turn off Failure to follow the above directions immediately.
  • Page 12: Cleaning Tips

    CLEANING TIPS 6 feet and always apply detergent from CAUTION bottom to top). Allow detergent to re- Before cleaning any surface an in- main on surface 1-3 minutes. Do not al- conspicuous area should be cleaned low detergent to dry on surface, if to test spray pattern and distance for surface appears to be drying, simply maximum cleaning results.
  • Page 13 keeping the spray nozzle approximately 6-8 inches from the cleaning surface (distance should increase when rinsing pin-striping or other sensitive surfaces). Always clean from top to bottom and from left to right. For best results, wipe surface dry with a chamois or soft dry cloth.
  • Page 14: Optional Cleaning Acces

    OPTIONAL CLEANING ACCESSORIES Optional accessories are available to Rotating Wash Brush (bayonet) further enhance your cleaning capabili- For more effortless cleaning of all ties. These accessories are accurate as smooth surfaces (painted, glass and of the printing date of this manual. plastic) try Kärcher's Rotating Wash Please check our website for pricing Brush.
  • Page 15 Wet Sandblasting Kit (bayonet) Why spend hours stripping old paint and rust by hand using harsh chemicals? Let Kärcher's Wet Sandblasting Kit do the work! Attach the kit to your pressure washer, add abrasive material and at- tack the rust and paint with our eco- friendly alternative.
  • Page 16: Troubleshooting

    TROUBLESHOOTING Disconnect the machine from the power CAUTION source before making any repair. Symptom Cause Solution Motor will not start On/Off switch is in the “OFF” Turn switch to the “ON” (I) posi- (0) position. tion Power cord is not plugged in. Plug in power cord. Electrical outlet does not sup- Try a different outlet.
  • Page 17 Oil Drip. Oil seals are damaged or Call Customer Support worn. Kärcher Customer Support Kärcher Customer Support USA and Canada Mexico Call: 1-800-537-4129 for help or visit Call: 01-800-024-13-13 for help or visit our website: our website: www.karcher.com.mx www.karcherresidential.com English...

Table of Contents