Sunbeam Pro Glide SR8700 User Manual page 10

Using your Pro Glide
any button, trigger or dial needs to be
pressed to power back up the boiler and
the iron. Allow the iron to heat up until
the thermostat light on the iron goes out
and the steam ready light illuminates
GREEN.
NOTE: The auto off is only activated after
15 minutes of the steam not being used.
NOTE: When you reactivate the iron
after it has been in auto off mode water
may have been trapped in the steam
hose. Therefore before using the steam
generator on a garment direct a shot
of steam into the air to release any
remaining condensation.
8
Steam Generator continued
®
Calc Clean Reminder
Mineral deposits in tap water solidify
when the water is heated and can build
up in the steam holes and boiler system
which can affect steam performance.
The Calc Clean light illuminates
WHITE to remind you when it is time
to flush the boiler. The Calc Clean light
illuminates after approximately 20
hours of use. It is important to regularly
flush out the boiler to maintain the
performance of the ironing system.
NOTE: If all the lights on the control
panel illuminate and flash you must
decalcify the unit immediately. If the
lights continue to flash after you have
decalcified the unit please call Customer
Services on 1300 881 861.
SEE CARE & CLEANING SECTION ON
PAGE 9.
Figure 6