Dimplex CXD2000H-NA Series Installation Instructions

Ceramic Indoor/Outdoor Radiant Heater
CXD2000H-NA Series

ImpORtANt INStRuCtIONS

When using electrical appliances, basic precautions should
always be followed to reduce the risk of fire, electric shock
and injury to person, including the following:
1. This heater is designed to be horizontally wall mounted
only, it must not be ceiling mounted.
2. Always ensure a safe mounting height, at or above a
minimum height of 72" (1.8m) from ground level, so that
the heater can not be touched when in operation.
3. The heater must be wall mounted level ± 5° to the
horizontal.
4. Do not locate the heater immediately above or below a
fixed socket outlet or connection box.
5. Always disconnect the heater from the electricity supply
before attempting to work on or near it.
6. Always ensure a safe means of access using an ac-
cess tower or properly supported ladder.
7. Do not cover the heater.
8. Keep combustible materials away from the heater.
9. Do not position patio furniture, sunshades, awnings and
other combustible materials too close to the heater.
10. Do not use heater if the elements are broken - as injury
may occur.
11. Allow adequate time (minimum of 30 minutes) for the
elements and body casing to cool before attempting to
work on the heater.
12. Wiring between the heater and the spur outlet or
isolation switch must be in a heat resisting cable (e.g.
polychloroprene).
WARNINg: Please ensure all packaging is removed
from the appliance before switching on. Remove the
guard as shown in Figure 3, remove element packaging
and replace guard.
SAve tHeSe INStRuCtIONS
Figure 1

general Information

Your Dimplex Ceramic Radiant Heater uses ceramic
elements which produce a high proportion of their output in
the long-wave infra-red. This provides a high comfort factor
- similar to the natural energy from the sun.
electrical
WARNINg: the installation of this appliance should
be carried out by a competent electrican and be in
accordance with National electrical Codes (NeC)
and local codes.
The CXD2000H-NA is designed for use on a 240V AC
single phase supply.
An all-pole isolating switch with a minimum separation of
0.01ft in each pole must fitted to facilitate isolation. This
switch must either be positioned inside a building or have
an IP rating against water ingress suitable for external
installation.
The appliance must be supplied through a residual current
device (RCD) having a rated residual operating current not
exceeding 30mA.
The appliance must be connected to a socket-outlet having
an grounding contact.
For supply connections use No.14 AWG or larger wire
suitable for at least 194°F(90°C).
The wiring to the appliance must be connected with a UL
approved watertight connection for outdoor use. Remove
rain shield for access to this connection and then replace
rain shield once connection is completed. Appliance must
have rain shield installed at all times during operation.
!
NOte: Always ensure the cable grip is tightened.

Installation Instructions

Heaters are supplied with an integral wall bracket which
may be fixed through the mounting holes to any suitable
structure. The bracket positions the heater at an angle of
45 degrees for optimum performance. The recommended
fixing height is 72" (1.8m) from ground level. (Figure 2)
The integral wall fixing bracket may be removed by fully
unscrewing to facilitate its fixing.
The sitting of the heater(s) should be such as to allow an
Figure 2
45
Heated Zone
7208100100R03