Clarion CZ505E Owner's Manual And Installation Instructions page 14

Notes of installation
1. Before installation, please make sure proper
connections are conducted and the unit
operates normally. Improper connection may
result in damage to the unit.
2. Use only accessories designed and
manufactured for this unit as other
unauthorized accessories may result in
damage to the unit.
3. Before installation, please fasten all power
cables.
4. DO NOT install the unit in the place where
close to hot area to prevent damage to
electrical components such as the laser
head.
5. Install the unit horizontally. Installing the unit
more than 30 degree vertically may result in
worse performance.
6. To prevent electric spark, connect the positive
pole first and then the negative pole.
7. DO NOT block the cooling fan exit to ensure
sufficient heating dissipation of this unit, or it
may result in damage to this unit.
Screwdriver
Unit Installation
Method A
1. Insert mounting bracket into dash board,
choose appropriate mounting tab according
to the gap width, bending the mounting
tab outwards with a screwdriver to fix the
mounting bracket in place.
2. Screw in 1 piece of M4×42 to the hole of the
unit back and put on a rubber cap over the
screw. (see picture below)
3. Slide the unit into the bracket until you hear
a click sound.
Rubber cap
Special Screw (M4x42)
Method B
M5x6
Dashboard
Mounting Frame
1. Insert this unit directly to the opening of the
dashboard.
2. Place M5×6 cylindrical screw through the
holes of the mounting frame located inside
the opening to holes of the unit and fasten
the screws to left & right.
Trim Ring Installation
Attach the trim ring around the front panel.
Disassemble trim ring
1. Push the trim ring to right and pull out the
Top
Bottom
6) Removing the Source Unit
right part.
2. Push the trim ring to left and pull out the left
part.
Disassemble the unit
1. Switch off the power.
2. Remove the panel.
3. Remove the trim ring.
4. Insert the removal keys straight back until
they lock, then pull the unit out.
5. Disconnect all the wires.
CZ505E
15