Thank you for purchasing this Clarion product. ∗ Please read this owner’s manual in its entirety before operating this equipment. ∗ Check the contents of the enclosed warranty card and keep it carefully with this manual. Contents 1. FEATURES ............................3 2.
THE COMPACT DISC PLAYER SHOULD NOT BE ADJUSTED OR REPAIRED BY ANYONE EXCEPT PROPERLY QUALIFIED SERVICE PERSONNEL. CHANGES OR MODIFICATIONS NOT EXPRESSLY APPROVED BY THE MANUFACTURER FOR COMPLIANCE COULD VOID THE USER’S AUTHORITY TO OPERATE THE EQUIPMENT. Bottom View of Source Unit CZ509A...
∗ Press the center of the DCP to close. 5. Strong impacts to the operating or display section can cause damage or deformation. 6. If the FLIP DOWN PANEL does not open fully, gently open it with your hand. CZ509A...
• Perform scan play for 10 seconds of each track while in CD/MP3/WMA/AAC/USB mode. [AUX] input jack • Input jack for connecting external device. (UP), (DN) buttons • Select folders while in MP3/WMA/AAC/USB [SOUND] button mode. • Press to switch to the sound adjust mode. CZ509A...
Page 6
• Commence fast-forward or fast-reverse mode. ] button • Perform preset scan while in the radio mode. • Play or pause a track while in CD/MP3/WMA/ AAC/USB/iPod mode. [Q] (EJECT) button • Press to eject disc. [CD SLOT] • Insert CDs here. CZ509A...
• If the DCP is dirty, wipe off the dirt with a soft, dry cloth only. CAUTION Be sure to close the HOLD FLAP for safety when removing the DCP. Attaching the DCP 1. Insert the right side of the DCP into the main unit. CZ509A...
• Press to perform repeat play. • Switches reception band. [RDM] button [x], [v] buttons • Press to perform random play. • Moves preset channels up and down. • Press and hold the button (1 sec.) to perform all random play. CZ509A...
• When replacing the battery, insert properly, with +/– polarities oriented correctly. • Do not subject battery to heat, or dispose of in fire or water. Do not attempt to disassemble the battery. • Dispose of used batteries properly. CZ509A...
CUSTOM : user custom (maximum). EXCITE : bass and treble emphasized mid emphasized Switching the display : bass and treble emphasized IMPACT Press the [DISP] button to select the desired B-BOOST : bass emphasized display. : no sound effect CZ509A...
US patents: 5510752, 5736897. BBE and BBE symbol are registered trademarks of BBE Sound, Inc. • During SOUND adjustment mode, if no operation is performed for more than 10 seconds, this mode can be cancelled and return to previous mode. CZ509A...
[ISR] button again to return to the previous 1. Select the desired station with seek tuning or mode. manual tuning. 2. Press and hold one of the [DIRECT] buttons (2 sec.) to store the current station into preset memory. CZ509A...
CD-RW disc, please select “ISO9660 level 1, 2 or JOLIET or Romeo” or APPLE ISO as the writing software format. Normal play may not be possible if the disc is recorded on another format. CZ509A...
● MP3/WMA/AAC disc WMA/AAC mode. Track ➜ Folder ➜ Title/Album ➜ Artist ➜ When the unit enters the CD/MP3/WMA/AAC Track ... mode, play starts automatically. If there is no disc loaded, the indication “NO DISC” appears in the title display. CZ509A...
This function allows you to play a track currently previous folder. being played in the MP3/WMA/AAC folder 2. To select a track, press the [x] or [v] repeatedly. button. 1. Press and hold the [RPT] button (1 sec.) to perform folder repeat play. CZ509A...
1. Press and hold the [RDM] button (1 sec.) to perform folder random play. ● To cancel play 1. Press the operating button previously selected. ∗ The various play mode is canceled and the various play off mode appears in the display for 2 seconds. CZ509A...
[x] or [v] button to select the contact “BT TEL” ➜ “BT AUDIO” name’s phone number. ∗ The connected device name will appear in the 4. Press the [ ] button to call the mobile display. phone No. CZ509A...
] button to select “MEMORY 1” 3-1. Press and hold the [ ] button (1 sec.) to to “MEMORY 5”, then press and hold the disconnect. ] button (1 sec.) to memory. ∗ Press and hold the [SOUND] button (2 sec.) to disconnect. CZ509A...
Page 20
“2” or “3”, then press the [ ] button to 2-1. Press “NOISE”. store in memory. 3-1. Press the [ ] or [ ] button to select “LOW” or “HIGH”. ∗ The factory default setting is “LOW”. CZ509A...
Page 21
The Bluetooth address 6 figures appears in the display. 3-1. Press the [ ] or [ ] button to display. ● Bluetooth Name This will display the name of the Bluetooth. 2-1. Select “BT NAME”. The Bluetooth name appears in the display. CZ509A...
3-2. Press and hold the [BND] button (1 sec.) to 2-1. Select “CONTRAST”. clear the old message. 3-1. Press the [ ] or [ ] button to adjust the 3-3. Press the [x] or [v] button to move the contrast. cursor. CZ509A...
3-1. Press the [ ] or [ ] button to select “ON” type. Each time you press the [BND] button, or “OFF”. the character type changes in the following order: Capital letters ➜ Numbers ➜ Symbols ➜ Capital letters… CZ509A...
1. Press and hold the [DISP] button (1 sec.). 2. Select “AUX SENS”. 3. Press the [ ] or [ ] button to select “HIGH”, “MID” or “LOW”. Note: • When AUX mode is selected, AUX IN sensitivity can be set. CZ509A...
USB memory devices. portable audio players, consult your nearest ∗ Devices compatible with “USB Mass Storage Clarion dealer, or visit Clarion’s website. Class” can be used merely by connecting to the host device, without need for special drivers or application software.
Page 26
USB/MTP mode is selected, since it may result in loss or damage to data on the USB memory/MTP device. Always backup and save important data on your computer. 2. Remove the USB memory/MTP device from the USB cable. CZ509A...
[v • For a list of compatible Apple iPod unit with the 3. Press the [ ] button. this model, please contact your Clarion dealer or www.clarion.com. 4. Press the [ ] or [ ] button to select “ON”...
Page 28
3. Press the [v] button to select the category. 2. Press the desired [DIRECT] (1-6) button to 4. When the track name display is showing, select the category. press the [v] button. ∗ Subfolders may be displayed, depending on the category. CZ509A...
Page 29
This unit supports the display of title information transmitted from a connected iPod. • Character code information is UTF-8; displayable characters include English alphanumerics, some symbols, and some umlaut characters. • Unsupported characters will be replaced by asterisks (*). CZ509A...
1. Turn down sound volume. Function can also be is operating. restored by turning the power off and on again. (Speaker volume is reduced automatically when the speaker protection circuit operates). 2. If the sound is muted again, consult our service department. CZ509A...
Page 31
Can’t insert the The device has been inserted Try reversing the connection direction of the device device. improperly. (usually the brand name surface should be facing left). The connector is broken. Replace with a new device. CZ509A...
Do not support the HUB Do not use the HUB devices. devices. If an error display other than the ones described above appears, press the reset button. If the problem persists, turn off the power and consult your store of purchase. CZ509A...
WMDRM to access their content. protect their intellectual property, including If you decline an upgrade, you will not be able copyrights. This device uses WMDRM to access content that requires the upgrade. software to access WMDRM-protected content. If the WMDRM software fails to CZ509A...