Advertisement
3. To display the datacomm configuration menu, press the soft key labeled:
<da tacomm conf ig> on the HP 2623
<port2 config> on the HP 2624 -- <port 1 config> if cable 92217E or 13222X
<datacoml con fig> on the HP 2625 and HP 2628
Your terminal will probably be set at the default configuration:
Baud Rate: 2400
Parity: None
EnqAck: YES
Appendix B
4. Using the tab and the softkey labeled <next choice>, tab to Baud Rate and press <next choice> until it
is set to 9600. Tab to Parity and set it to O.
5. Press the softkey labeled <save con fig> to save and exit this configuration menu.
HP 150 -- the Touchscreen
This procedure outlines the configuration instructions in the Getting Started with Your HP Touchscreen
Personal Computer manual. Because this personal computer has a touchscreen, you can press the softkeys
on the keyboard or the associated label on the screen to get the same results.
To configure your Touchscreen as the console, complete the following steps:
1. Press the User System key to display the function labels.
2. Press (or touch) <config keys>.
3. Press (or touch) <port 1 con fig> to display the datacomm configuration menu. Your Touchscreen will
probably be set at the default configuration:
BaudRate: 2400
Parity: O's
DataBits: 7
EnqAck: YES
4. Using the tab and <next choice>, tab to Baud Rate and press <next choice> until you see 9600.
5. Press (or touch) <save con fig> to save and exit this configuration menu.
6. Press (or touch) <modes> to display modes labels.
B-3
Advertisement
