Installation; Please Note Electrical Connection 10-11 - Morphy Richards EG820CFD-PM Installation & User's Instructions

Table of Contents

Advertisement

Installation

Please Note
Electrical connection
The oven is fitted with a plug and
must be only connected to a
properly installed earthed socket.
In accordance with the appropriate
regulations,
the socket must only
be installed and the connecting
cable must only be replaced by a
qualified electrician.
no longer accessible following
installation and all-pole isolating
switch must
be present on the
installation side with a contact gap
of at least 3mm.
.
Select a level surface that provide
1
enough open space for the intake
and/or outlet vents.
The rear surface of appliance shall be
placed against a wall.
(1) The minimum installation height is
85cm.
(2) Leave a minimum clearance of 12
inches (30cm) above the oven.
(3) Do not remove the legs from the
bottom of the oven.
(4) Blocking the intake and/or outlet openings
can damage the oven.
( ) Place the oven as far away from
5
radios and TV as possible.
Operation of microwave oven may
cause interference to your radio or TV
reception.
2. Plug your oven into a standard household
outlet. Be sure the voltage and the
frequency is the same as the voltage
and the frequency on the rating label.
WARNING: Do not install oven over a
range cooktop or other heat-producing
appliance. If installed near or over a heat
source, the oven could be damaged and
the warranty would be void.
If the plug is
10
30cm
20cm
20cm
min85cm

Hide quick links:

Advertisement

Table of Contents
loading

This manual is also suitable for:

Eg820cfdf-pm

Table of Contents