Symbol MC3000 User Manual page 113

6. If the network is not an Ad Hoc network, the encryption settings available are Disabled and WEP. Tap WEP encryption and
select an appropriate authentication type; Open, Shared, WPA or WPA-PSK. See
authentication types. If the Disabled encryption setting is selected, there are no authentication types available. See
7-4 for a description of the authentication values available for each of the encryption type selections.
WLAN123
Figure 7-7. Wireless Properties, Authentication Selection
7. The Enable 802.1X authentication options are available for non Ad Hoc networks. Tap the Enable 802.1X authentication
check box to enable the 802.1X authentication. This selection also enables the EAP type selection.
8. Tap to select the Encryption settings. The available options are WEP and TKIP.
settings.
Figure 7-8. Wireless Properties, Encryption Selection
Encryption
Disabled
WEP
TKIP
WLAN123
WLAN123
Table 7-5. Encryption Options
Use the Disabled option when no data packet encryption is needed over the network.
Selecting this option provides no security for the data being transmitted over the network.
Select WEP to select a key index 1-4 and input the key into the Network key box. The Key
can be a 10, 26, 32 or 64 Hex digit value or 5, 13, 16, 32, digit ASCII value.
Select this option for the client adapter to use Wireless Protected Access (WPA) via TKIP.
If this selection used with the WPA-PSK authentication then the pass key must be entered
into the Network key box.
Table 7-3 for a description of the
WLAN123
Table 7-5 describes the encryption option
WLAN123
Description
WLAN Configuration 7-7
Table
WLAN123