Operation; Using The Air Compressor - CEN-TECH 62374 Owner's Manual & Safety Instructions

Operating Instructions
Using the Work Light
1. To turn the Work Light on, press
the Work Light button.
2. To turn flashing lights on, press the
Work Light button again.
Jump Starting a Vehicle
Note: Read the vehicle owner's manual pertaining
to jump starting prior to using the Power Pack.
1. Press the Battery Test button to verify that the
Power Pack is fully charged. Recharge as
needed, following the instructions in the "Charging
the Power Pack" section on page 6.
2. Turn off the vehicle ignition switch and all
accessories (lights, radio, climate control, etc.).
3. Turn Clamp Power Switch on the Power
Pack to their OFF position. You may
leave the Work Light on if needed.
WARNING! DO NOT TOUCH POSITIVE AND
NEGATIVE BATTERY CLAMPS TOGETHER.
3. Connect the red Positive Battery Cable to
vehicle's positive battery terminal. Connect
the black Negative Battery Cable to a non-
moving metal part of the vehicle.

Using the Air Compressor

1. Press the Battery Test button to verify that the
Power Pack is fully charged. Recharge as needed,
following the instructions in the "Charging
the Power Pack" section on page 6.
2. Open the Air Hose Compartment on the
back of the unit and pull out the air hose.
3. Check the proper inflation level for the object that is
being inflated.
Tire Inflation
1. Position the Tire Inflator over the valve stem and
push down firmly, making sure it is fully seated.
2. Press the lever down. (See Figure D.)
Page 8 For technical questions, please call 1-888-866-5797.
3. To turn the Work Light off, press the
Work Light button again.
WARNING! DO NOT CONNECT TO THE
NEGATIVE TERMINAL OF THE BATTERY.
4. When the correct connection has been made, turn
the Clamp Power Switch to the ON position.
5. WAIT FIVE MINUTES, then start the
vehicle. If the vehicle does not start, wait an
additional 3 minutes before trying again.
WARNING! THE VEHICLE WILL NOT START IF
YOU DO NOT WAIT AT LEAST 5 MINUTES.
6. After the vehicle is started, turn the Clamp
Power Switch to the OFF position. Remove
the black Negative Battery Cable first, and
then the red Positive Battery Cable.
Adapter
installed
Air Hose
Figure D
3. Press the Air Compressor Switch on.
Note: Monitor the Air Pressure Gauge on the
front of the unit to avoid over-inflation.
4. When the proper inflation level has been
reached, press the Air Compressor Switch off.
5. Lift the lever and remove the hose.
Tire Inflator
Lever
pressed
down
Item 62374