Operation; Using The Work Light; Jump-Starting A Vehicle; Running/Charging Dc Appliances/Usb Devices - CEN-TECH 62376 Owner's Manual & Safety Instructions

Operating Instructions

Using the Work Light

1. To turn the Work Light on, press
the Work Light button.
2. To turn flashing lights on, press the
Work Light Button again.

Jump-Starting a Vehicle

Note: Read the vehicle owner's manual pertaining
to jump-starting prior to using the Power Pack.
1. Press the Battery Test button to verify that the
Power Pack is fully charged. Recharge as
needed, following the instructions in the "Charging
the Power Pack" section on page 6.
2. Turn off the vehicle ignition switch and all
accessories (lights, radio, climate control, etc.).
3. Turn Clamp Power Switch on the Power
Pack to the OFF position. You may
leave the Work Light on if needed.
WARNING! DO NOT TOUCH POSITIVE AND
NEGATIVE BATTERY CLAMPS TOGETHER.
3. Connect the red Positive Battery Cable to
vehicle's positive battery terminal. Connect
the black Negative Battery Cable to a non-
moving metal part of the vehicle.
Running/Charging DC Appliances
1. Press the Battery Test button to verify that the
Power Pack is fully charged. Recharge as
needed, following the instructions in the "Charging
the Power Pack" section on page 6.
2. Make sure the total wattage of the appliance
is within the range of the Power Pack. See
"DC Appliance Compatibility" on page 7.
Running/Charging USB Devices
1. Press the Battery Test button to verify that
the Power Pack is fully charged. Recharge
as needed, following the instructions in the
"Charging the Power Pack" section on page 6.
Page 8 For technical questions, please call 1-888-866-5797.
3. To turn the Work Light off, press the
Work Light button again.
WARNING! DO NOT CONNECT TO THE
NEGATIVE TERMINAL OF THE BATTERY.
4. When the correct connection has been made, turn
the Clamp Power Switch to the ON position.
5. WAIT FIVE MINUTES, then start the
vehicle. If the vehicle does not start, wait an
additional 3 minutes before trying again.
WARNING! THE VEHICLE WILL NOT START IF
YOU DO NOT WAIT AT LEAST 5 MINUTES.
6. After the vehicle is started, turn the Clamp
Power Switch to the OFF position. Remove
the black Negative Battery Cable first, and
then the red Positive Battery Cable.
3. Make sure that the Clamp Power
Switch and appliance are off.
4. Plug the appliance into the 12VDC Outlet.
5. Turn on the appliance.
6. When finished using, turn off and
unplug the appliance.
2. Plug the device into the USB Port.
3. When finished, unplug the device from the USB Port.
Item 62376