CEN-TECH 62374 Owner's Manual & Safety Instructions page 9

Using Hose Adapters
1. Three adapters are included with the Power Pack that
can be attached to the Tire Inflator. (See Figure E.)
Figure E
Running/Charging DC Appliances
1. Press the Battery Test Button to verify that the
Power Pack is fully charged. Recharge as
needed, following the instructions in the "Charging
the Power Pack" section on page 6.
2. Make sure the total wattage of the appliance is
within the range of the Power Pack. See "DC
Appliance Compatibility" on page 7.
Running/Charging USB Devices
1. Press the Battery Test button to verify that
the Power Pack is fully charged. Recharge
as needed, following the instructions in the
"Charging the Power Pack" section on page 6.
Record Product's Serial Number Here:
Note: If product has no serial number, record month and year of purchase instead.
Note: Some parts are listed and shown for illustration purposes only, and are not available individually
as replacement parts. Internal parts are not user-serviceable and are not available.
Item 62374 For technical questions, please call 1-888-866-5797.
2. Attach the proper adapter to the Tire
Inflator for the object to be inflated.
3. Insert the adapter into the object's
receptacle and press the lever down.
4. Press the Air Compressor Switch on.
Note: Monitor the Air Pressure Gauge on the
front of the unit to avoid over-inflation.
5. When the proper inflation level has been
reached, press the Air Compressor Switch off.
6. Lift the lever and remove the hose.
WARNING! Do not overinflate any object.
3. Make sure that the Clamp Power
Switch and appliance are off.
4. Plug the appliance into the 12VDC Outlet.
5. Turn on the appliance.
6. When finished using, turn off and
unplug the appliance.
2. Plug the device into the USB Port.
3. When finished, unplug the device from the USB Port.
Page 9