Operation - CEN-TECH 60657 Owner's Manual

Operating Instructions
Using the Work Light
1. To turn the Work Light on, press
the Work Light Switch.
Jump-Starting a Vehicle
Note: Read the vehicle owner's manual pertaining
to jump-starting prior to using the Power Pack.
1. Press the Battery Test Button to verify that the
Power Pack is fully charged. Recharge as needed,
following the instructions in the Setup section under
"Charging the Power Pack" on page 6.
2. Turn off the vehicle ignition switch and all
accessories (lights, radio, climate control, etc.).
3. Turn all switches on the Power Pack
to their OFF positions. You may leave
the Work Light on if needed.
WARNING! DO NOT TOUCH POSITIVE AND
NEGATIVE BATTERY CLAMPS TOGETHER.
3. Connect the red Positive Battery Cable to
vehicle's positive battery terminal. Connect
the black Negative Battery Cable to a non-
moving metal part of the vehicle.
Running/Charging DC Appliances
1. Press the Battery Test Button to verify that the
Power Pack is fully charged. Recharge as needed,
following the instructions in the Setup section under
"Charging the Power Pack" on page 6.
2. Make sure the total wattage of the appliance is within
the range of the Power Pack. See Setup section
under "DC Appliance Compatibility" on page 6.
Page 8 For technical questions, please call 1-800-444-3353.
2. To turn the Work Light off, press the
Work Light Switch again.
WARNING! DO NOT CONNECT TO THE
NEGATIVE TERMINAL OF THE BATTERY.
4. When the correct connection has been made, turn
the Clamp Power Switch to the ON position.
5. WAIT FIVE MINUTES, then start the
vehicle. If the vehicle does not start, wait an
additional 3 minutes before trying again.
WARNING! THE VEHICLE WILL NOT START IF
YOU DO NOT WAIT AT LEAST 5 MINUTES.
6. After the vehicle is started, turn the Clamp
Power Switch to the OFF position. Remove
the black Negative Battery Cable first, and
then the red Positive Battery Cable.
3. Make sure that the Clamp Power
Switch and appliance are off.
4. Plug the appliance into the 12VDC Outlet.
5. Turn on the appliance.
6. When finished using, turn off and
unplug the appliance.
Item 60657