Page 1
16 Channel 5-in-1 High Definition 1080p DVR with 1HDD Bay and Alarms WAHDN2161A Quick Start Guide Please read these instructions carefully before operating the unit and keep for further reference.
Page 2
Intro Section Please read this instruction carefully before operating the product and keep it for further reference. All examples and pictures used here are for reference only. The contents of this manual are subject to change without notice. CAUTION: • Please check the device and the accessories after getting the device.
H.264 encoding. Real time recording is achievable up to 1080p video supporting resolution up to 5MP in AHD, TVI and IP. Both The WAHDN2161A is a highly versatile cost effective solution suitable for many CCTV applications.
Quick Start Guide 16 Channel 5-in-1 High Definition 1080p DVR with 1HDD Bay and Alarms 1.3 Specification Model WAHD2161A System Embedded Linux BNC x16 Analogue Video Input BNC interface (1.0Vp-p, 75Ω) TVI / AHD / CVI : 5MP / 4MP / 1080p / 720p / WD1 (Live) 8CH (Up to 16CH) IP Video Output Up to 5MP @ 30fps...
2.0 HDD Installation This series of the product supports 2 SATA hard drives. Please make sure that the device is powered off before the installation. The pictures of the installation are only for reference. Loosen the screws to open the cover. 2.
3.0 Rear Panel Instruction The interfaces of the rear panel are for reference only. I nt ernet Name Description ALARM OUT Relay output, connect to external alarm ALARM IN Alarm input for connecting sensor Ground VIDEO IN Video input CVBS CVBS output AUDIO OUT Audio output...
4.0 Start Up and Shut Down Startup Connect the monitor and the power. 2. The device will boot and the power indicator will display blue. 3. A wizard window will pop up. Shutdown Click “Start” and then select “Shutdown” icon. This will bring up a shutdown window. The device will shut down by clicking “OK”...
5.0 Login The default username is admin and the default password is 123456. You must configure the wizard if you start the DVR for the first time and you may change the password when you configure the wizard for the first time. You can skip the settings wizard next time. Click “Start”...
6.0 Configurations and Connections 6.1 Ananlogue Camera Connection First connect the camera to the DVR. Then go to Start → Settings → Camera→ Manage Camera → Camera Signal to checkmark the video mode. Theactual signals input shall correspond to the video mode. Please refer to the User Manual for details.
Page 11
Quick Start Guide 16 Channel 5-in-1 High Definition 1080p DVR with 1HDD Bay and Alarms 5. Checkmark the device you want to add and then click “Add” button.The DVR will automatically refresh the cameras and return to “Edit Camera” interface. “Online” status means connecting the device successfully and you will see the live image.
7.0 UPnP You can use the UPnP function to enable the fast connection of the device to WAN via a router without port mapping. Go to Start → Settings → Network → UPnP, and enable UPnP and then click “Apply” button to save.
8.0 NAT NAT Settings The DVR shall be powered on and connected to the network. 2. Go to Start → Settings → Network → TCP/IP. You can obtain the IP address, subnet mask and gateway automatically. You can also manually enter them according to the actual network situation.
9.0 Manual Recording and Playback 9.1 Manual Recording Before recording, please install and format a HDD. In the live interface you can see the menu toolbar. Click button to start recording. Click it again to stop recording. You can also click to check the status of the recording.